Search found 10 matches

by Macdiver
Tue Oct 31, 2017 12:32 pm
Forum: Trojan Boats Forum
Topic: 1983 f-32 AC placement
Replies: 8
Views: 5390

1983 f-32 AC placement

Where and how is the AC located in the F-32? How about a generator?
by Macdiver
Wed Aug 23, 2017 5:26 pm
Forum: Trojan Boats Forum
Topic: f-32 with chrysler 318 water temp problem
Replies: 2
Views: 2298

f-32 with chrysler 318 water temp problem

My F-32, with Chrysler 318 have a water temp problem. Guage stuck at low temp then went to 240 and stayed there. changed thermostat but problem persists. There are two sensors wires in front and below the water tank, when the lower one is disconnected the temperature guage goes back to normal but th...
by Macdiver
Tue May 31, 2016 8:58 pm
Forum: Trojan Boats Forum
Topic: oil transmission cooler for Chrysler 318
Replies: 1
Views: 2075

oil transmission cooler for Chrysler 318

Looking for an oil transmission cooler for my Chrysler 318. Anyone have a source to contact. Thanks, Macdiver
by Macdiver
Thu Jul 30, 2015 9:05 pm
Forum: Trojan Boats Forum
Topic: Air conditioner for an F32
Replies: 15
Views: 13484

Re: Air conditioner for an F32

I have installed a mermaid system in my 1985 and my 1990 has a cruiseairr system installed. Make sure you get one that the controls allow a deicing mode. Also my boat is in mystic if you would like to take a look. Hi Andy: Thanks for the reply, yes, I would like to take a look at your F32 air syste...
by Macdiver
Sun Jul 19, 2015 11:38 am
Forum: Trojan Boats Forum
Topic: Air conditioner for an F32
Replies: 15
Views: 13484

Air conditioner for an F32

Has anyone put in an air conditioner in a F32, mine is a 1983 flybridge model? Macdiver
by Macdiver
Tue Aug 26, 2014 3:44 pm
Forum: Trojan Boats Forum
Topic: Head vacuum breaker assembly
Replies: 2
Views: 2184

Head vacuum breaker assembly

Looking for a Mansfield vacuum breaker assembly (911-M28) for the head on a 1983 Trojan. Mansfield was bought out and the vacuum assembly may have been altered. Has any had to replace this assembly? and with what? Thanks, Captains
Macdiver
by Macdiver
Thu Sep 15, 2011 10:25 am
Forum: Trojan Boats Forum
Topic: Engine failure at low rpm
Replies: 3
Views: 2301

Engine failure at low rpm

The day started out normally with my 83 trojan with chrysler 318s. After running a short distance at about 2500 rpm and slowing down to about 800 rpm The starboard engine shut down. I could restart at about 1200 rpm and keep it running but when reduced to below 1000 rpm the engine would die. Didn't ...
by Macdiver
Wed Jun 08, 2011 10:53 am
Forum: Trojan Boats Forum
Topic: 83 Trojan leaking hydraulic steering
Replies: 0
Views: 2402

83 Trojan leaking hydraulic steering

Behind the wheel on the bridge one of the hydraulic steering lines is leaking. Has anyone had this problem and how do you rectify it, any suggestions would be appreciated. Is there an o ring involved? Thanks in advance for any help. Gene
by Macdiver
Fri Apr 09, 2010 5:40 pm
Forum: Trojan Boats Forum
Topic: Trojan F32 transom railing
Replies: 3
Views: 3128

Trojan F32 transom railing

Ahoy Captains:

I am look for a 30 inch length of railing that is typically oven the gunwale of a 1983 F32 Trojan. Does anyone have a piece at least that length or do you know where I can obtain one?

Thanks,

Macdiver :
by Macdiver
Wed Feb 24, 2010 11:01 pm
Forum: Trojan Boats Forum
Topic: 83 Trojan F-32
Replies: 43
Views: 18750

83 Trojan F-32

Forum Users:

I'm looking at cutting a door in the transom of my 83 F-32. Has anyone attempted this and/or does anyone have any suggestions? The main problem is cutting the door completely out with the top teak board in tack with the hinges possibly on the starboard side.

Thanks, Gene