Trojan Boat Forum

Well, that's good news for sure.

Any photos of the old and new breakers and your panel? Those look to be single-pole breakers. My 78 F36 uses a 3 pole FWIW

I've seen plenty of speedometers over the years, most without an odometer and more on smaller boats. Nowadays, they're kind of useless with GPS that can tell you speed and log the miles, too. And a GPS can be set at Knots. If you were to average, say, 10 mph, that would be 750 hours. Running slower ...

Speedometer.. Not factory.

Here is the install, just do it backward. Sorry I can't download it for some reason. It should be in your manual. Beaconmarine sells them.

Thank you for the update.

wetsu82 wrote: ↑Mon Oct 28, 2024 5:48 pm 1985 Trojan International 10m, blower unit in ceiling not blowing cold or warm air, just blowing air. Control unit on wall seems to be functioning properly! Can't read the model number on this plate.

Is the compressor coming on? Pumping water? Has the charge been checked?

Almost forgot, Parts for Trojan may be easier to find than the Maxum. Beacon has a lot, a lot more than you see on their Trojan store page.

I would not call a F-series boat a Cadilac of boats more of a Chevy. But it has a classic look and feel as it is a Classic. A Maxum is also Mid level boat. I don't know what model Maxum you are referring to so I can't be pacific. The Maxum being a newer boat will likely have more features and new st...

Gauges powering up? Gear shifts in Neutral?

I have seen the tubs get holes in them, even a pinhole can cause them to suck air. I do not recommend sharing a pick-up. Some tubes are part of the tank, But you can always put a new pickup w/tube inside them.

Probably is screws going into a wood block. The transom itself is not cored. Best to do the repair out of the water. Maybe fill the holes with epoxy.

Trim tab or clynder bolt? A temp quick fix underwater epoxy. If you replace a screw or bolt 3M 5200 quick cures underwater

Contact Bob at Beacon Marine, he may have what you need. best to call.

Beacon Marine Supply © 2024
Forks Township, PA and Columbia, PA
bob at beaconmarinesupply dot com
609-713-4602

SillyGoose wrote: ↑Fri Aug 30, 2024 7:06 pm I would really like a full canvas enclosure like the one you have, where did you get it?

Enclosures are normally custom-made. A marine canvas shop can do it. What Trojan do you have?