Trojan Boat Forum

Things get changed over the years on old boats Selling parts? What happened with FB? "Sorry, I am tired of Facebook, so I am here. Just e-mail me if you want any info that I might have! FYI, I have access to 2 - 1976 F32 Sedans, 1 1974 F32 Sedan, 1 F36 Sedan (with Aft Deck Helm), and 1 1978 F26...

As a rule the exhaust should get lower as it gets to the stern assuming you have stern exhaust. You did not say what Trojan you had some had stern some had underwater and some side exhaust. Due to the boats construction sometimes turns were used.

That is a good question. A lot of the cleaners for mold/mildew have a lot of fumes. Not something I would want to use in that area.

Shaft is 1 3/8"

I'll apologize up front for interrupting this conversation with a new topic (or at least different stats). I have a 1989 F36 sportfish with twin crusader 454's. The old owner put 4 blade props on the boat and the performance is suffering greatly. PROWLERFISH: Can you tell me the correct prop size a...

Polyester should be fine. Here is a link to G10 They have different types. Wood is also fine.

https://www.mcmaster.com/products/~/mul ... ars/?s=g10

Plywood was used I believe. Todays plywood is not like it used to be I used Oak on mine ( F36). Others have used marine plywood, marine plywood with epoxy, plastic boards and G10 fiberglass I would never use treaded plywood, it has too many voids. If I was to replace my Oak I would go with G10. G10 ...

Check around the battery area too.

The Tri cabin never came with 318s. Assuming you're not talking about a tri-fly. They only came with the 360 (250hp) Chrysler and Mercruiser 255hp(351?) Factory props are 20x17. When picking props I often recommend reducing the pitch from factory specs. As very few are in factory new condition/ If f...

Assuming nothing was changed it sounds like a ground issue. But it is odd it's the upper and lower. If it was only one engine I would think about a sender issue. Still posable, any work done over the winter?

Check your grounds to the panels.
Is this at idle and warm?

Joe, That tach is not original. The hour meter is digital. They did not have digital back then and the OEM tachs were also cable-driven. A new hour meter will be at zero. The OEM would likely say trojan on them. Not sure who made them. Any photos of the other gauges so I can tell you if they are OEM...

It is possible but it is much better and easier done from the top. I had the same issue and rather than cut it open, I used a product called injectadeck. I was happy withe the results. Here is a link to the thread on my repair https://www.trojanboats.net/wforum/viewtopic.php?p=111878&hilit=injec...

Congrats and good luck. Make sure the inspection is really a Survey done by a NAMS or a SAMS-accredited surveyor. At 2 years it is time to paint the bottom again. Hope all goes well.

Any photo of your Alt? Beacon Marine has some

https://www.trojanboats.net/zencart/ind ... th=102_110