Trojan Boat Forum

Hey all, just wondering if anyone here has veered away from the Mopar module and ran an aftermarket ignition system, if so, any benefits? Thanks, oh and still wondering about the 8 holes above my galley sink

Interstate battery store made my new cables up, I used some 12-2 Romex I had around to mock up the lengths.

Hey, bringing this back to life. In the F25 brochure, what are the 8 holes cut in above the galley sink? For liquor bottles? Thanks.

Book shelf bracket?

Pulling the thermostat first is also pretty good idea, my 2 cents. Sat is my day to pull

Went in today, rolled across fox harbor in 3 1/2 ft of water, very nerve racking.

1/4 pipe tap, brass barbed air hose fitting. I used the 12v side of the ballast resistor,

Here's my idea, I initially sweated the cost, but it made such a huge in improvement with hot starts, fuel economy, I couldn't have been happier. Edelbrock 1409, everything bolted right up , fired right up,

New 1409, The carter 6212 went through its last rebuild. Install pretty straight forward, after a few adj, idles perfect, responds great, very excited to see how it runs in the water. About 3 more weeks!

I second the 3m restorer and wax, I had great results, my only complaint is after essentially bleaching and scrubbing the hull and top sides was the tannish color of the wax made the non skid look super white making everything else appear off white.. This product after a good scrub with a scotch bri...

Put together a tender for the summer, keeping our two Boston's over the weekend was creating some problems. Came across this particular model at the Chicago boat show. after months of research, I settled on this one. It is a Silver marine 240 Nemo AD, and a Honda 2hp long shaft out board, not a lot ...

Does this count? Pretty excited about rock in these out at the chicago boat show.

I don't want to poke the bear here , but would a reason "not" to fog an engine over winter be?

This sounds a lot like a old gm one wire alternator, that is self exciting, externally regulated. These use a resistor wire to keep from back feeding the ignition, where it would keep running after the key is turned off. If these aren't wired right it it cooks the coils, some coils like the pertroni...

I attempted that, the access on deck is centered over the sending unit leaving no room to pull out the pick up. I'm still up in the air on this tank removal. I "think" if I remove the risers and and exhaust along with the ignition tray. It might come out ;/ I'm for sure not cutting the dec...