Trojan Boat Forum

Good question. First I would not like an inverter that comes on automatically. With the exception of running the refrigerator. What happens if it comes on, and the AC or microwave is on? At 1000 watts it can't power high loads and surly can not power all your electrical needs. Not sure how you have ...

Sounsa like reglator or line maybe pluged

The tank should have nothing to do with the dock water pressure. The water pump acts like a check valve so the dock water does not go to the tank. or at least it should. Is the pump working normally?

There is a pressure regulator for shore water that may limit your pressure.

As Larry said it is a cutlass bearing. While it can be replaced with the strut and shaft in place with the right tool. I Prefer to remove the strut when possible. Bob at Beacon will have the Bearing Beacon Marine Supply © 2023 Forks Township, PA and Columbia, PA bob at beaconmarinesupply dot com 609...

I have one side of our F32 stair hardware missing. Have looked all over at marinas and this web site . Anybody have an idea who might have a set of these chrome brackets? Call Bob what you see in the online store is just a small fraction of what Beacon has. Beacon Marine Supply © 2023 Forks Townshi...

Tgornik wrote: ↑Mon May 01, 2023 12:10 pm

Thought of this but would still have to mess with the diameter of the hole so just decided to plug and start over..

Thanks again.
Tg

If going to a transducer that is larger thread and nut I plug the hole by epoxy in a piece of wood so center the hole saws bit. Makes it easier

Hampton Va Salt ponds area

Engines look great

Very nice, moving along. You're just up the bay from me.

The 12 to 1, I believe refers to the hole Diameter. I also believe 12 to 1 is way overkill for a small hole like this. I would taper the hull a bit and grind some around the edges ( not as deep as your drawings ) fill and glass over. I have done this more than once without issues. Another easier but...

I like it.

You may want to to contact Beacon marine. They should have the shipping height.

Give Robert Cushman a call at Beacon marine..

Bob Cushman, Owner
Beacon Marine Supply
Bob@BeaconMarineSupply.com
(609)713-4602

http://www.trojanboats.net/wforum/viewt ... c6f8cb17bf

Beacon marine sells pre cut packing.

Give Bob a call.

Beacon Marine Supply © 2023
Forks Township, PA and Columbia, PA
bob at beaconmarinesupply dot com
609-713-4602