Search found 81 matches
- Mon May 30, 2011 3:20 pm
- Forum: Trojan Boats Forum
- Topic: v-drives for 25 and 26 Trojans
- Replies: 11
- Views: 4160
- Wed May 25, 2011 6:41 am
- Forum: Trojan Boats Forum
- Topic: replace copper fuel lines?
- Replies: 10
- Views: 4822
Here is some info that may be helpful, taken from the link below. Fuel Hose: When fuel hose is used it must be either USCG Type A1-15, USCG Type B1-15. Where you use it determines what type you use. From the fuel inlet on the engine (usually the fuel pump) to the carburetor you must use Type A1-15. ...
- Tue May 24, 2011 6:54 am
- Forum: Trojan Boats Forum
- Topic: v-drives for 25 and 26 Trojans
- Replies: 11
- Views: 4160
Nickbezy I hope you don't mind a couple of questions. I'm looking for dimensions. 1) height from the inside of the hull(hopefully not over the hollow keel) to the CL of the input shaft on the v-drive. 2) height from the CL of the input shaft on the v-drive to the underside of the cockpit deck. I kno...
- Sun May 22, 2011 9:57 am
- Forum: Trojan Boats Forum
- Topic: v-drives for 25 and 26 Trojans
- Replies: 11
- Views: 4160
I had not picked a specific engine yet, although I've seen some 4 cylinder fords(apx.65 hp) in a couple of Trojans and chriscrafts/allmands of that size with no height problems. They where used for small shallow water shrimping boats with top end of 7 kts. At 5kts, according to the re-builder, they ...
- Sun May 22, 2011 8:45 am
- Forum: Trojan Boats Forum
- Topic: v-drives for 25 and 26 Trojans
- Replies: 11
- Views: 4160
- Sat May 21, 2011 7:32 pm
- Forum: Trojan Boats Forum
- Topic: v-drives for 25 and 26 Trojans
- Replies: 11
- Views: 4160
v-drives for 25 and 26 Trojans
Can anyone tell me what years had v-drives for these two models.
Thanks
Mike
Thanks
Mike