Trojan Boat Forum

I used Marblehead trading to pick up my F32 in Georgia and bring it up here a few years back. I am sure if you call a few boat dealers and yards in your area you will find one. Bridge has to come off and mark all wires and controils

What is the yellow wire that goes from battery to black "switching box ? The reason is I notice my mechanic left it un attach to battery Any help in the wiring for the box??

It is the aft one. Am I correct in reading that the 2x4 is screwed into a support which is glassed in and the 2x4s are not glassed in only srewed in? How are the side plywood flooring attach? Why a pain to take off? I was actually thinking if I ripe up floor would replace it with 3/4 plywood Any tho...

I notice that I had a weak/soft spot on floor where one of engine covers rest on a straping srcewed to a 2x4. After looking saw 2x4 is splitting at bottom where straping is screwed in. How much of a job is it to replace 2x4 and how is it attached under?? It runs the width of salon.. I amk thinking o...

Notice that temp gauges on one of the engines will shut down and than come back on in a while. Gauges shut down on both stations so I am assuming it might be a ground wire. What is best way to track problem? Is wiring for temp gauges on thermostat housing? Ant help is appreciated

My battery charger on 1981 F32 has not worked the last few seasons. Any suggestions on best replacement? Also is charger wired to generator and shore power?

I have a 1981 F32 and looking for ideas on updating walls and ceiling in head. Not sure how to handle job or what to use for material. Want to replace counter, sink, and faucet which should be straight forward I hope. I put in a electric head hooked up to fresh water tank. Now want to update head an...

I was thinking of installing a salt water wash down pump. I was wondering if I could use the same circuit as my fresh water pump--jump it off the existing pump. I was thinking would not use both pumps at the same time. Am I nuts or not??

I ended up putting flushing valves on the raw water intake hoses on both engines and gem. It makes it is a lot easier to hook hose up to flush engines and than switch to fill up to anti freeze. Well worth the small investment

Over the last 2 seasons have been determined 2 get gen set running correctly. Have it running but will not idle evenly---keeps uneven idle. Heres the kicker. During the high humid weather we had, started it up and ran great! Did this a few days during that hot spell and was fine. Pumping water and s...

I noticed yesterday on topside when I put panel switch lights, on all of gages go all the way to the right. When I switch it off they go back to normal. Any ideas on how to chase this down and where to start?

Looking for opinions. What looks better with or with out cockpit rails? My son says I should remove them, but I like to keep boat original.

Installed a in hull transducer by garmin for a 740s--however not getting readings from it--any ideas?

What was the approx cost to replace steering system??

Notice the other night a very small fluid leak on top side steering housing. I have seen some wetness there last year. I know steering system is original and no longer being made. What should I do or expect. Ant easy fix??