Trojan Boat Forum

Give Robert Cushman a call at Beacon marine..

Bob Cushman, Owner
Beacon Marine Supply
Bob@BeaconMarineSupply.com
(609)713-4602

http://www.trojanboats.net/wforum/viewt ... c6f8cb17bf

Beacon marine sells pre cut packing.

Give Bob a call.

Beacon Marine Supply © 2023
Forks Township, PA and Columbia, PA
bob at beaconmarinesupply dot com
609-713-4602

hope it's ok to piggyback on this thread we are in marina del rey southern california we have owned the boat for 3 years now we have not painted the bottom and it is likely that the previous owner did not either (maybe 5 years) the service that cleans the bottom is not complaining and says there ar...

Moderator wrote: ↑Mon Mar 27, 2023 11:17 pm You could make bushing or spacer. Or just don't overtighten

Make a spacer, should be easy and no worries.

I don't know of any Trojans with them. However I have a friend with them on a 42 ocean. He likes them over regular trim tabs. Not sure if its auto system. With that said it would be much cheaper to increase your tab size.

The model # is part of the hull ID# You most likely have a model 440

The Aft wall was plywood and made to be removable. You do have the aft engine correct? Later models had the engines under the salon floor. Aft decks were known to leak many owners fiber glass the aft decks to fix the leaks many are rotted. Do you have the model number? Its located on plate on or by ...

Any outside photos? Looks like the back wall was repaired at some point. I am not sure but thinking it was plywood. as far as the hours difference the can be several causes. Bad hour meter or its wiring? Engine or trans was inop for along time or broke down a lot. As far as what the go for? Seen the...

Specifications 19899 F29, F32, F36, 10, 10.8, 1,1 12. 13, and 14 Meter International boats

Thanks for the update.

Now onto the nut and bolts. How big of raw water inlets will I need to cool these power plants. And banks marine is producing this motor at 575 hp/429kw for pleasure craft duty. I’m calling them on the way home to get information. Banks should have guidelines for installing their engines. They will...

On the salon AC you have a remote condenser in the ceiling of the salon so no ducting. On the forward unit , it is self-contained and installed in "closet" You have a vent(s) directly out of the "closet" with no ducts. And you also have ductwork/tubes running to the V-berth front...

Haymaker55 wrote: ↑Sat Jan 14, 2023 2:21 pm It’s got 1.5” shafts now. That would shave many things off the change list. I do agree it will be a bit over powered with this setup but where I’m headed having extra power will come in handy.

Should be 1 3/8 now mine where changed when repowered. Did you ever check the ID numbers?

The boat has 20x21s props with 1.91:1 gears now. I could never get above 3500 with the 440s. I figured 1:1 with the same props after the new motors? I’m going from 330hp and 375lbs tq. To 500hp and 850 lbs tq. The max torque on the 500hp Duramax is 750, not 850 on the chart I found. so you 750 at t...