F25 Blueprints / Dimensions
Posted: Tue Jun 05, 2018 2:22 pm
Hey all,
I'm anxiously awaiting the arrival of my newly acquired F25.
It's going to make the journey Saturday via Lake Ontario, Oswego River, the Erie Canal and finally to it's new home on Cayuga Lake.
Here's my dilemma.
I'm trying to get my rail system set up.
I'd like to have it somewhat dialed in by the time it arrives.
Does anyone know the:
Hull width at the water line?
Optimal bunk spread?
Optimal bunk length
Center of Gravity (How far into the bunks do I need to be? fore-heavy? Aft-heavy?)
Distance from Stern to Drive shaft opening?
Others?
I can fine tune later, but I'd really like some preliminary figures to work with.
Presently, I'm debating 12' to 14' bunks. Too much? Not enough?
Blueprints?
Schematics?
Etch-a-sketch drawing?
Anything.
Any assistance greatly appreciated.
Thank you.
I'm anxiously awaiting the arrival of my newly acquired F25.
It's going to make the journey Saturday via Lake Ontario, Oswego River, the Erie Canal and finally to it's new home on Cayuga Lake.
Here's my dilemma.
I'm trying to get my rail system set up.
I'd like to have it somewhat dialed in by the time it arrives.
Does anyone know the:
Hull width at the water line?
Optimal bunk spread?
Optimal bunk length
Center of Gravity (How far into the bunks do I need to be? fore-heavy? Aft-heavy?)
Distance from Stern to Drive shaft opening?
Others?
I can fine tune later, but I'd really like some preliminary figures to work with.
Presently, I'm debating 12' to 14' bunks. Too much? Not enough?
Blueprints?
Schematics?
Etch-a-sketch drawing?
Anything.
Any assistance greatly appreciated.
Thank you.