Page 1 of 1

Bulkhead replacement

Posted: Sun Jul 29, 2018 11:21 am
by Merchdoor
F30 - I am replacing my bulkhead between the cabin and engine room. While removing the rotted wood I noticed that the rear deck is supported only in the middle by the two main stringers. Since there was so much bad work done on this boat I am questioning if this support is correct. I have two main stringers running down the center spaced approx. 2’ apart and two others spaced approx. 2’ over from the centers.

Re: Bulkhead replacement

Posted: Sun Jul 29, 2018 12:42 pm
by prowlersfish
Should also have support on the sides , you may not see it . What model F30 they made several

Re: Bulkhead replacement

Posted: Mon Jul 30, 2018 5:58 am
by Merchdoor
Thank you. I have a Clean Machine.