Trojan Boat Forum

El L Sea wrote: ↑Thu Feb 21, 2019 12:54 pm We use products from Yacht Devices. They are easy to hook up and they make a wide range of not only sensors, but control products for NMEA2000.

How do those hook up?

Captrichc wrote: ↑Thu Feb 21, 2019 6:01 pm

El L Sea wrote: ↑Thu Feb 21, 2019 12:54 pm We use products from Yacht Devices. They are easy to hook up and they make a wide range of not only sensors, but control products for NMEA2000.

How do those hook up?

Directly to the NMEA backbone, that's why I like them. This is my engine room temp sensor.

Simrad system will be delivered today. Cant wait to set it up. I want to redo the witing b4 i seal the deck again for easy access.

Also i designed my new hatch. I will post pics later tonight

Here are some pics of the new system.!!!!

Now i need to figure out where to mount the total scan transducer.

Very nice

I have the same radar and like it a lot. If only I knew how to take advantage of all its features. Then again, I really enjoy learning how to use it!

WayWeGo wrote: ↑Tue Feb 26, 2019 6:00 pm I have the same radar and like it a lot. If only I knew how to take advantage of all its features. Then again, I really enjoy learning how to use it!

I cant wait to set mine up.

Ordered my nmea 2000 network today, along with the Nolan rs11, 2 lowrance fuel flow sensors. My birthday came a few days early

Both new tanks are installed and all hoses ran. Reimstalled pressure pump for fresh water and installed the saltwater wash down pump. Tomorrow ill take up the electric for everything and stsrt the template for the floor.

You're on a roll! Keep up the good work and thanks for keeping us in the loop!

Just picked up my props they look almost brand new.

Cleaned up the wiring today. Ill take some pics once i have everything mounted where it needs to be b4 i make the template for the floor itself.

Template made for the floor. Cut the wood and i am going to be installing the deck today.

Some new pictures.