WOT

This forum is for comments and the exchange of information relating to Trojan Boats and boating. Please do not post used parts or boats For Sale in this area. For general, non-boating topics please use our "General Discussions" section.

Note: Negative or inflammatory postings will not be tolerated.

Moderators: BeaconMarineBob, Moderator, BeaconMarineDon

User avatar
captainmaniac
2019 Gold Support
2019 Gold Support
Posts: 1854
Joined: Sat Apr 30, 2005 10:26 pm
Location: Burlington, Ontario

Re: WOT

Post by captainmaniac » Fri Oct 11, 2019 7:08 pm

WayWeGo wrote:
Fri Oct 11, 2019 12:20 am
I think captainmainiac meant to say small block (318/340/360) and big block (383/400/440) engines...
As I said - not an expert... I don't build the darn things, just use them!

User avatar
prowlersfish
2019 Gold Support
2019 Gold Support
Posts: 11738
Joined: Sat Nov 05, 2005 6:56 pm
Location: Lower Chesapeake Bay ,Va

Re: WOT

Post by prowlersfish » Fri Oct 11, 2019 7:28 pm

Away wrote:
Fri Oct 11, 2019 2:38 am
And I am loaded with carbon due to excessive cruising at 1500. Looking at using Sea Foam in another post.

Sea Foam Any experience with this product for heavey carbon removal. Either added to the fuel supply or added to the crank case. Good, bad or better alternatives.
Why do you think you have a heavy carbon build up ? While I am not a member of the sea foam "club" it can't hurt . Nor can a long run at 3000 in fact it should do you some good .
TROJAN F36 Conv.
6BTA Cummins diesels
Life is to short for a ugly boat :D
2009 TROJAN RENDEZVOUS
Port Kinsale 2010 & 2011. Solomons get together 2011.

kallen
Sporadic User
Posts: 96
Joined: Wed Jun 04, 2008 8:48 pm
Location: Ivy lee, ontario,canada

Re: WOT

Post by kallen » Fri Oct 11, 2019 10:14 pm

Something we use to do was dribble water down the throat of the carb to steam out carbon with the engine at 2000 rpm. Dont let the engine stall out.
You could also try some combustion chamber cleaner and follow the instructions.

User avatar
P-Dogg
2019 Forum Supporter
2019 Forum Supporter
Posts: 848
Joined: Wed Jun 22, 2011 7:15 pm
Location: Near Baltimorgue, where Maryland proves to the nation every day that gun control doesn't work.

Re: WOT

Post by P-Dogg » Sat Oct 12, 2019 10:05 am

Away wrote:
Fri Oct 11, 2019 2:38 am
And I am loaded with carbon due to excessive cruising at 1500.
How do you know?
I needed a less expensive hobby, so I bought a boat!

mikeandanne
Moderate User
Posts: 600
Joined: Sun Sep 09, 2012 11:30 am

Re: WOT

Post by mikeandanne » Sat Oct 12, 2019 11:58 am

Away, do your spark plugs look black and furry and the carbs run rich ( real smelly exhaust)?
78 F 32

User avatar
Away
Sporadic User
Posts: 145
Joined: Sat May 09, 2015 5:53 pm
Location: Lake Simcoe Ontario

Re: WOT

Post by Away » Sat Oct 12, 2019 2:48 pm

Yes, Yes and Yes. We actually blew out a ton of carbon. Floating all over the place at start up. Marina mechanic was there, he confirmed. Next day could not get engine to fire up. Checked for fuel, checked compression, cleaned up the distributor cap. ok pulled a plug YUK dry black fuzzy. Others wet. Replaced them all fired right up. wanted to try SEA FOAM and a good half our run at 3000 rpm before sending carbonators in for an overhaul next spring.
F32 Fly 1975

mikeandanne
Moderate User
Posts: 600
Joined: Sun Sep 09, 2012 11:30 am

Re: WOT

Post by mikeandanne » Sat Oct 12, 2019 6:43 pm

Away wrote:
Sat Oct 12, 2019 2:48 pm
Yes, Yes and Yes. We actually blew out a ton of carbon. Floating all over the place at start up. Marina mechanic was there, he confirmed. Next day could not get engine to fire up. Checked for fuel, checked compression, cleaned up the distributor cap. ok pulled a plug YUK dry black fuzzy. Others wet. Replaced them all fired right up. wanted to try SEA FOAM and a good half our run at 3000 rpm before sending carbonators in for an overhaul next spring.
Sounds very much like the carbs need attention, that will give you a black powdery looking residue in the exhaust water. Maybe the choke plates are stuck shut. If they are the original carter afb style carbs, I wouldn't waste too much effort on them. Good carb rebuilders up here are pricey and I don't mean just someone putting a kit in them.

You going to Florida this winter ?
78 F 32

User avatar
Away
Sporadic User
Posts: 145
Joined: Sat May 09, 2015 5:53 pm
Location: Lake Simcoe Ontario

Re: WOT

Post by Away » Sun Oct 13, 2019 8:38 pm

Yes.

Not a mechanic how would I know if these are. If they are the original carter afb style carbs. If the answer is yes, are you indicating a different solution.
F32 Fly 1975

User avatar
WayWeGo
2019 Gold Support
2019 Gold Support
Posts: 662
Joined: Fri Feb 13, 2015 11:13 am
Location: Oakton, VA / Rhode River - Chesapeake Bay

Re: WOT

Post by WayWeGo » Sun Oct 13, 2019 10:41 pm

The AFB carbs can develop air leaks at the butterfly shafts when old and that is expensive to fix. It's easier to buy Edelbrock 1409 carbs and install them.
1975 F-36 Convertible
Twin Chrysler 440's

Post Reply