Prop strut backing plates

This forum is for comments and the exchange of information relating to Trojan Boats and boating. Please do not post used parts or boats For Sale in this area. For general, non-boating topics please use our "General Discussions" section.

Note: Negative or inflammatory postings will not be tolerated.

Moderators: BeaconMarineBob, Moderator, BeaconMarineDon

Briank117
Registered user
Posts: 23
Joined: Sun Nov 10, 2019 1:41 pm

Re: Prop strut backing plates

Post by Briank117 »

I'm planning to coat the new wood with exterior polyeurethane--likely tomorrow afternoon after things dry out from the past 2 days of rain showers. Is that sufficient, or should I consider another product?

User avatar
WayWeGo
2020 Gold Support
2020 Gold Support
Posts: 696
Joined: Fri Feb 13, 2015 11:13 am
Location: Oakton, VA / Rhode River - Chesapeake Bay

Re: Prop strut backing plates

Post by WayWeGo »

For oak, I would use West Systems 105/205 epoxy on all sides of the backing plates, including inside the bolt holes.
1975 F-36 Convertible
Twin Chrysler 440's

Post Reply