How fast with this diesle?

This forum is for comments and the exchange of information relating to Trojan Boats and boating. Please do not post used parts or boats For Sale in this area. For general, non-boating topics please use our "General Discussions" section.

Note: Negative or inflammatory postings will not be tolerated.

Moderators: BeaconMarineBob, Moderator, BeaconMarineDon

Post Reply
Curt33
Registered user
Posts: 5
Joined: Mon Apr 06, 2020 4:52 pm

How fast with this diesle?

Post by Curt33 »

I inherited a 1977 Trojan 26 with a fly bridge.
I’ve always owned smaller outboard boats, and I am very ignorant when it comes to inboard boats,and boats of this size in particular. Plus, it has a Yanmar JHE marine diesle, around 44Hp. Before I put money into it, I was wanting to get an estimate of what cruising speed I might achieve with this small engine. I’m thinking that getting on plane will be out of the question. I figure 10 knots max, in a purely displacement mode. Anyone got thoughts on this? Previous owner is deceased, so I have nothing to go on. If any of you men have any thoughts as to speed and/or fuel consumption, I sure would appreciate it. I really want to save this old boat. Needs a little work, but engine does start.
User avatar
RWS
Ultimate User
Posts: 2857
Joined: Sat Feb 18, 2006 7:01 am
Location: West Coast Florida
Contact:

Re: How fast with this diesle?

Post by RWS »

I believe this is a sailboat engine

Unlikely you will achieve planning speed

That said, your fuel economy at displacement speed will be off the charts !

Suggest you perform a full service and REPLACE THE IMPELLER.

RWS
1983 10 Meter SOLD after 21 years of adventures
Yanmar diesels
Solid Glass Hull
Woodless Stringers
Full Hull Liner
Survived Andrew Cat 5,Eye of Charley Cat 4, & Irma Cat 2
Trojan International Website: http://trojanboat.com/

WEBSITE & SITELOCK TOTALLY SELF FUNDED
User avatar
prowlersfish
2024 Gold Support
2024 Gold Support
Posts: 12645
Joined: Sat Nov 05, 2005 6:56 pm
Location: Lower Chesapeake Bay ,Va

Re: How fast with this diesle?

Post by prowlersfish »

Cruising at hull speed (about 6.5 knots ) you will burn about 1 gal a hour . Top speed would likely be a little above 10 knots with a fuel burn of 3 gal a hour . I ran the info on a calculator . The boat / engine will be happiest at hull speed or less . Anything above hull speed and you start to plow water .


Sounds like a cool boat just don't be in a hurry :D

Any photos ?
Boating is good for the soul
77/78 TROJAN F36 Conv.
6BTA Cummins diesels
Life is to short for a ugly boat :D
Curt33
Registered user
Posts: 5
Joined: Mon Apr 06, 2020 4:52 pm

Re: How fast with this diesle?

Post by Curt33 »

Here’s a few shots of the boat. She is very dirty, but she is structurally sound. Had not been ran in about a year when I got it. A quick battery charge, and the little yanmar fired right up. Shut her down after 3 min of a nice idle, with the intention of not cranking her again until All fluids and filters are changed and impellers are replaced. A clean fuel cell with fresh diesle is in order too. I included a photo of the trailer to get some opinions from you men. Most of the wobble rollers need replacing, as well as all keel rollers. Gonna get expensive pretty quick. If any of you folks can supply dimensions and bunk layout of a trailer with runners for this boat, I think I’m gonna go that rout. I welcome any and all opinions and advice from you guys.
Attachments
ADABF653-2E0D-4023-BF35-091BC2C978D1.jpeg
ADABF653-2E0D-4023-BF35-091BC2C978D1.jpeg (190.67 KiB) Viewed 5152 times
B4A4D9D8-CCED-478F-AEC8-90F8238BDCC2.jpeg
B4A4D9D8-CCED-478F-AEC8-90F8238BDCC2.jpeg (188.33 KiB) Viewed 5152 times
F17AB1F9-8455-4183-B1AA-A6A38C3BCE1C.jpeg
F17AB1F9-8455-4183-B1AA-A6A38C3BCE1C.jpeg (208.19 KiB) Viewed 5152 times
7357C3D5-9AC3-4F68-A438-9496E9C85A27.jpeg
7357C3D5-9AC3-4F68-A438-9496E9C85A27.jpeg (211.44 KiB) Viewed 5152 times
6628C11A-7188-4B02-A558-995F5864F80B.jpeg
6628C11A-7188-4B02-A558-995F5864F80B.jpeg (168.82 KiB) Viewed 5152 times
FE2F512B-C042-4EB8-9A57-128B2382BBF1.jpeg
FE2F512B-C042-4EB8-9A57-128B2382BBF1.jpeg (158.81 KiB) Viewed 5152 times
FD8D6B89-3518-4D74-B2C1-F1E6A3B2E11A.jpeg
FD8D6B89-3518-4D74-B2C1-F1E6A3B2E11A.jpeg (205.56 KiB) Viewed 5152 times
User avatar
RWS
Ultimate User
Posts: 2857
Joined: Sat Feb 18, 2006 7:01 am
Location: West Coast Florida
Contact:

Re: How fast with this diesle?

Post by RWS »

Other than the DOCK LADDER on the transom, this boat has a great deal of great possibilities, as long as you realize it's limitations regarding wind, current and seas.

Don't think she's a candidate for haulover inlet

If you don't know what that is, just go to YOUTUBE and type in those two words

Otherwise she can be a really sweet, economical boat for some PURPOSEFUL fun.

Keep us posted on your progress :)

RWS
1983 10 Meter SOLD after 21 years of adventures
Yanmar diesels
Solid Glass Hull
Woodless Stringers
Full Hull Liner
Survived Andrew Cat 5,Eye of Charley Cat 4, & Irma Cat 2
Trojan International Website: http://trojanboat.com/

WEBSITE & SITELOCK TOTALLY SELF FUNDED
User avatar
prowlersfish
2024 Gold Support
2024 Gold Support
Posts: 12645
Joined: Sat Nov 05, 2005 6:56 pm
Location: Lower Chesapeake Bay ,Va

Re: How fast with this diesle?

Post by prowlersfish »

Great looking boat , It should clean up nice . Looks like someone put a lot into this boat at one time . Can't help you much on the trailer as I have seen very few on a trailer .
Boating is good for the soul
77/78 TROJAN F36 Conv.
6BTA Cummins diesels
Life is to short for a ugly boat :D
Curt33
Registered user
Posts: 5
Joined: Mon Apr 06, 2020 4:52 pm

Re: How fast with this diesle?

Post by Curt33 »

Ran the boat for about 6 miles today. Little diesel run like a clock. Prowlerfish was exactly right, best cruise speed was between 6-7 at 1900rpm. Running the little engine faster than that only resulted in a small gain in speed. Spending the next few days tearing down and rebuilding the trailer, then the major clean-up, fluids, belt, hoses, and impeller changeouts.

The huge swim ladder is an asset. My friends and I are avid Divers/spearfishermen. That nice swim platform and big ladder is gonna come in real handy. We won’t be running out our usual 30 mile in this slow boat, but at least we will be riding in comfort for our shorter runs.

Any suggestions on the best methods to flush the fresh water side of the heat exchanger? Was just planning on using the same Preston flush as used on automobiles. Looks really nasty in there, so something needs to be done. Thanks for any and all advice.
User avatar
prowlersfish
2024 Gold Support
2024 Gold Support
Posts: 12645
Joined: Sat Nov 05, 2005 6:56 pm
Location: Lower Chesapeake Bay ,Va

Re: How fast with this diesle?

Post by prowlersfish »

Preston flush should be fine . the flush it out with fresh water over and . Now this is the important part . Use only Yanmar coolant or Dexcool . Do not use "compatible "with " Suitable with " or universal coolants . Yanmars are great engines , but they are very coolant sensitive . The wrong coolant can and will do a lot damage .

If I scared you , that was the idea :wink:
Boating is good for the soul
77/78 TROJAN F36 Conv.
6BTA Cummins diesels
Life is to short for a ugly boat :D
Curt33
Registered user
Posts: 5
Joined: Mon Apr 06, 2020 4:52 pm

Re: How fast with this diesle?

Post by Curt33 »

Concerning anodes, where all do you guys recommend they be installed/replaced on this boat? Combed through the info on this site and learned a lot, but was hoping you may have some ideas specific to this boat. Boat will be staying in salt water, so is zinc optimal? Where all should I make sure I place them? Haven’t got the hull out of the water yet to see what all is installed currently.

Sorry for all the questions, and all you folks help is appreciated.
User avatar
prowlersfish
2024 Gold Support
2024 Gold Support
Posts: 12645
Joined: Sat Nov 05, 2005 6:56 pm
Location: Lower Chesapeake Bay ,Va

Re: How fast with this diesle?

Post by prowlersfish »

you need one on the shaft and one on the rudder . If you have trim tabs and they are drill put them there . And don't forget the engine zincs . I do recommend Zinc.

Btw any engine photos ? Like to see the install .
Boating is good for the soul
77/78 TROJAN F36 Conv.
6BTA Cummins diesels
Life is to short for a ugly boat :D
User avatar
RWS
Ultimate User
Posts: 2857
Joined: Sat Feb 18, 2006 7:01 am
Location: West Coast Florida
Contact:

Re: How fast with this diesle?

Post by RWS »

Yannies are GREAT diesel motors, however they are VERY SENSITIVE to maintenance requirements.

Over the last 14 years of ownership, I have only replaced the starter solenoids - BUT....

I have been on top of the maintenance 100% which in my case required coolant changes every 2 years.

WATCH THOSE ENGINE ZINCS - especially critical with ALUMINUM ENGINE COMPONENTS

Suggest you get the owners manual and shop manual - these resources are available at www.boatdiesel.com - well worth the $25 annual fee

RWS
1983 10 Meter SOLD after 21 years of adventures
Yanmar diesels
Solid Glass Hull
Woodless Stringers
Full Hull Liner
Survived Andrew Cat 5,Eye of Charley Cat 4, & Irma Cat 2
Trojan International Website: http://trojanboat.com/

WEBSITE & SITELOCK TOTALLY SELF FUNDED
Curt33
Registered user
Posts: 5
Joined: Mon Apr 06, 2020 4:52 pm

Re: How fast with this diesle?

Post by Curt33 »

After much more time and money than I planned, I finally got the trailer completed, and hauled the boat out this morning. Much cleaning to be done. Any advice for running the little Yanmar while on land? How do you supply the raw cooling water? Any connection for a garden hose, or some kind of muffs as used on an outboard? I’m thinking of rigging a garden hose attachment just past the seacock.

Prowlerfish gave theoretical performance figures for this hull and engine combo that turned out to be right on the money. Any chance you could give a cruise/max speed estimate if I installed a 230hp diesle? Not really sure what I’m going to do with the boat, but to be useable for me, I’m going to need a cruise better than 6-7 mph. Thanks in advance for your help.
Post Reply