Needle in a hay stack (Main salon aft port window)

This forum is for comments and the exchange of information relating to Trojan Boats and boating. Please do not post used parts or boats For Sale in this area. For general, non-boating topics please use our "General Discussions" section.

Note: Negative or inflammatory postings will not be tolerated.

Moderators: BeaconMarineBob, Moderator, BeaconMarineDon

Post Reply
User avatar
Wes
Moderate User
Posts: 301
Joined: Thu Feb 02, 2006 10:03 am
Location: Clinton, Connecticut

Needle in a hay stack (Main salon aft port window)

Post by Wes » Tue Feb 21, 2006 5:09 pm

I purchased a 1983 10 meter flybridge/aft cabin last fall. Before I purchased the boat the previous owner had to have the starboard engine replaced. This required removing the aft port side and center main salon plexiglass windows. When the yard was replacing the curved port side window it cracked. They hired a local glass shop to replace the window and the shop did a lousey job using 1/8 inch lexan. To top it off the glass shop discarded the original window. I understand that Trojan only made 4 of this model. To recreate the window is going to be a MAJOR project. Does anyone know of a place that might have a part like this or of one of the other 3 boats that might not still be afloat? I sure would appreciate any info on this.

User avatar
prowlersfish
2019 Gold Support
2019 Gold Support
Posts: 11673
Joined: Sat Nov 05, 2005 6:56 pm
Location: Lower Chesapeake Bay ,Va

Post by prowlersfish » Wed Feb 22, 2006 8:46 pm

Did you check with Bob here at trojan boats ? he may have the drawings so you have one made in not maybe marine tech may have the drawings


Paul
TROJAN F36 Conv.
6BTA Cummins diesels
Life is to short for a ugly boat :D
2009 TROJAN RENDEZVOUS
Port Kinsale 2010 & 2011. Solomons get together 2011.

Post Reply