F-36 Fuel Tank Drawings

This forum is for comments and the exchange of information relating to Trojan Boats and boating. Please do not post used parts or boats For Sale in this area. For general, non-boating topics please use our "General Discussions" section.

Note: Negative or inflammatory postings will not be tolerated.

Moderators: BeaconMarineBob, Moderator, BeaconMarineDon

Post Reply
User avatar
Danny Bailey
Moderate User
Posts: 473
Joined: Thu Dec 29, 2005 10:44 pm
Location: Oriental, NC

F-36 Fuel Tank Drawings

Post by Danny Bailey » Fri Mar 03, 2006 10:16 pm

Anyone know where I can get dimensioned drawings of the right and left gas tanks for a 1980 F-36. I need to have aluminum ones built for diesel repower.

User avatar
prowlersfish
2019 Gold Support
2019 Gold Support
Posts: 11672
Joined: Sat Nov 05, 2005 6:56 pm
Location: Lower Chesapeake Bay ,Va

Post by prowlersfish » Sun Mar 12, 2006 9:33 pm

Danny, did you check with bob here at trojan boats.net ? if not marinetech may have it
TROJAN F36 Conv.
6BTA Cummins diesels
Life is to short for a ugly boat :D
2009 TROJAN RENDEZVOUS
Port Kinsale 2010 & 2011. Solomons get together 2011.

Buckknekkid
Sporadic User
Posts: 158
Joined: Sat Oct 29, 2005 8:22 am
Location: Taranna

up close and personal

Post by Buckknekkid » Wed Mar 15, 2006 6:35 pm

Im replacing the aft bulkhead right now so the forward tanks are exposed. still need em?
F36 ~
SHES SOLDDDDDD

User avatar
Danny Bailey
Moderate User
Posts: 473
Joined: Thu Dec 29, 2005 10:44 pm
Location: Oriental, NC

Post by Danny Bailey » Sun Mar 19, 2006 4:16 pm

Sure. If your aft bulkhead is out, would be easy to measure the aft end. Thanks

Buckknekkid
Sporadic User
Posts: 158
Joined: Sat Oct 29, 2005 8:22 am
Location: Taranna

Im going to start tomorrow

Post by Buckknekkid » Sun Mar 19, 2006 9:53 pm

we are putting in the new bulkhead port side tomorrow. the angle on the tank is also critical. the aft section is trapezoid so I'll figure out the angle also. One thing on reinstalling is to fabricate small brackets to stabilbize the longitudinal supports under the salon. these can attach to the tank location structures. Photos will show. :idea:
F36 ~
SHES SOLDDDDDD

Buckknekkid
Sporadic User
Posts: 158
Joined: Sat Oct 29, 2005 8:22 am
Location: Taranna

Post by Buckknekkid » Mon Mar 20, 2006 4:30 pm

17.5 inches wide, 23.5 inches deep check out http://boatdesign.net/forums/showthread ... #post80536 and look closely.
F36 ~
SHES SOLDDDDDD

Post Reply