F-36 Fuel Tank Drawings
Posted: Fri Mar 03, 2006 10:16 pm
Anyone know where I can get dimensioned drawings of the right and left gas tanks for a 1980 F-36. I need to have aluminum ones built for diesel repower.
Trojan Boat Forum
*THE* forum for active Trojan Boaters...
http://www.trojanboats.net/wforum/
F-36 Fuel Tank Drawings
Page 1 of 1
Posted: Sun Mar 12, 2006 9:33 pm
Danny, did you check with bob here at trojan boats.net ? if not marinetech may have it
up close and personal
Posted: Wed Mar 15, 2006 6:35 pm
Im replacing the aft bulkhead right now so the forward tanks are exposed. still need em?
Posted: Sun Mar 19, 2006 4:16 pm
Sure. If your aft bulkhead is out, would be easy to measure the aft end. Thanks
Im going to start tomorrow
Posted: Sun Mar 19, 2006 9:53 pm
we are putting in the new bulkhead port side tomorrow. the angle on the tank is also critical. the aft section is trapezoid so I'll figure out the angle also. One thing on reinstalling is to fabricate small brackets to stabilbize the longitudinal supports under the salon. these can attach to the tank location structures. Photos will show. 
Posted: Mon Mar 20, 2006 4:30 pm
17.5 inches wide, 23.5 inches deep check out http://boatdesign.net/forums/showthread ... #post80536 and look closely.