quick project (for a change )

prowlersfish · Post by **prowlersfish** » Sun Jul 21, 2013 9:27 pm

I just added 2 foot switches on the bow for the windlass . Took about 30 minutes .

vabeach1234 · Post by **vabeach1234** » Sun Jul 21, 2013 10:13 pm

Nice.
But how long did it take you to decide where you wanted them? I know if it were me, it would have taken a month of just thinking about it.

prowlersfish · Post by **prowlersfish** » Sun Jul 21, 2013 10:44 pm

Unlike the transom door that took years of thinking about it , I did this on impulse .I found a deal and bought them was even looking .

alexander38 · Post by **alexander38** » Mon Jul 22, 2013 5:56 am

Did you take pics? As you know I have the same Good Winch, show your wire hookup ans such..

prowlersfish · Post by **prowlersfish** » Mon Jul 22, 2013 6:45 am

Just the one photo I posted . Wiring is simple , the red wire from each switch to power , then the other wire from each swith to the small "triger" termal on the solnoid(s )

alexander38 · Post by **alexander38** » Tue Jul 23, 2013 3:41 pm

No doubt it was ez..but a picture is worth a 1000 words....

Never mind

prowlersfish · Post by **prowlersfish** » Tue Jul 23, 2013 7:28 pm

prowlersfish wrote:Just the one photo I posted . Wiring is simple , the red wire from each switch to power , then the other wire from each swith to the small "triger" termal on the solenoid(s )

Just to make it clearer the other wire goes to the same termals that the helm switch uses .

If i have my camera with me next time I can take a shot , not much to see just some solenoids and wires .

Trojan Boat Forum

quick project (for a change )

quick project (for a change )

Re: quick project (for a change )

Re: quick project (for a change )

Re: quick project (for a change )

Re: quick project (for a change )

Re: quick project (for a change )

Re: quick project (for a change )