Small Fiberglass Job

gitchisum · Post by **gitchisum** » Mon Jan 06, 2014 9:37 pm

Well, the PO had removed the ladder and done a repair job on the deck that was delaminating. So thought I would take that opportunity to resurface and have a new non skid in the cockpit.

First step, get the hatch into somewhere warm. Check!

Next step

I wonder what's under there?

: This can't be good; step1.jpg (31.91 KiB) Viewed 4939 times

So I wonder how bad this gets?

: Think we will stop here; step2.jpg (25.17 KiB) Viewed 4939 times

The good news is, should be solid when I'm done

Commissionpoint · Post by **Commissionpoint** » Mon Jan 06, 2014 9:51 pm

Oh bugger. What a fun project.

I am sure once you are finished it will be great.

willietrojan · Post by **willietrojan** » Tue Jan 07, 2014 11:58 am

Just a question

How come you did not work on it from the bottom side? then you would not have to much in the way of finish work

prowlersfish · Post by **prowlersfish** » Tue Jan 07, 2014 1:08 pm

I was thinking the same thing When I did my F30 I fliped the deck over and did it.

Willie , I was just thinking about you . I was looking at a photo of St Mikes with you in it .
Hope all is well .

gitchisum · Post by **gitchisum** » Tue Jan 07, 2014 4:26 pm

Mostly because the bottom looked better than the top!!!!

PO had made some "customization" that was coming apart at the seams. So my intent was to cut that out and reglass.

First cut

Second cut

MattSC · Post by **MattSC** » Wed Jan 08, 2014 9:27 pm

It will be well worth it when you're finished. Hope you had a good season with the boat

gitchisum · Post by **gitchisum** » Fri Jan 10, 2014 12:58 pm

New core, glassed up and painted.

Now wait for some spring weather to get after the rest of the problems.

: hatch complete.jpg (16.43 KiB) Viewed 4829 times

Paul · Post by **Paul** » Fri Jan 10, 2014 8:51 pm

Looks good. What's the hole for?

prowlersfish · Post by **prowlersfish** » Fri Jan 10, 2014 9:47 pm

Nice work

gitchisum · Post by **gitchisum** » Sat Jan 11, 2014 11:21 am

Hole is for a deck plate. Have the sea cock for for my wash down pump under there.

It was installed by the PO and was done nicely. So I left it.

Trojan Boat Forum

Small Fiberglass Job

Small Fiberglass Job

Re: Small Fiberglass Job

Re: Small Fiberglass Job

Re: Small Fiberglass Job

Re: Small Fiberglass Job

Re: Small Fiberglass Job

Re: Small Fiberglass Job

Re: Small Fiberglass Job

Re: Small Fiberglass Job

Re: Small Fiberglass Job