wiring schematic
Moderators: BeaconMarineBob, Moderator, BeaconMarineDon
-
- Registered user
- Posts: 59
- Joined: Sun Jun 17, 2018 4:59 pm
wiring schematic
1979 f30 flying bridge with twin 225 chryserers. first of let me say i hate wiring. starboard oil gauge reads correctly but since we bought the boat the port has been pegged at 80. we tested the gauge by swapping it with the starboard gauge so we know the gauge isnt the issue. the dual senders on both engines look identical, both alarms work fine when you turn the key. tested both the ignition and ground wires and both read properly. ran a jumper straight from the sender to the gauge but it still wont read properly. i did read the sticky about trojan gauges as all the gauges have a ac on the bottom of the gauge i assume for ac delco. can anyone get me going in the right direction before my head explodes???
- prowlersfish
- 2024 Gold Support
- Posts: 12645
- Joined: Sat Nov 05, 2005 6:56 pm
- Location: Lower Chesapeake Bay ,Va
Re: wiring schematic
Are both upper and lower stations doing this ? Did you swap senders ? Also a shorted/bad gauge on one station can effect the other
Boating is good for the soul
77/78 TROJAN F36 Conv.
6BTA Cummins diesels
Life is to short for a ugly boat
77/78 TROJAN F36 Conv.
6BTA Cummins diesels
Life is to short for a ugly boat
-
- Registered user
- Posts: 59
- Joined: Sun Jun 17, 2018 4:59 pm
Re: wiring schematic
we didnt look at the top set of gauges. yes we did switch senders but that didnt help