Refitting a 1976 F-32 Journal

This forum is for comments and the exchange of information relating to Trojan Boats and boating. Please do not post used parts or boats For Sale in this area. For general, non-boating topics please use our "General Discussions" section.

Note: Negative or inflammatory postings will not be tolerated.

Moderators: BeaconMarineBob, Moderator, BeaconMarineDon

User avatar
prowlersfish
2019 Gold Support
2019 Gold Support
Posts: 11491
Joined: Sat Nov 05, 2005 6:56 pm
Location: Lower Chesapeake Bay ,Va

Re: Refitting a 1976 F-32 Journal

Post by prowlersfish » Tue Feb 05, 2019 10:45 pm

You may get lucky many don't like it . Removing mine was my first improvement I did to my F36 .That light made it hard to see at night . But unless you have another place to mount a light you don't have much of choice . I was lucky and had a hard top .
TROJAN F36 Conv.
6BTA Cummins diesels
Life is to short for a ugly boat :D
2009 TROJAN RENDEZVOUS
Port Kinsale 2010 & 2011. Solomons get together 2011.

User avatar
WayWeGo
2019 Gold Support
2019 Gold Support
Posts: 585
Joined: Fri Feb 13, 2015 11:13 am
Location: Oakton, VA / Rhode River - Chesapeake Bay

Re: Refitting a 1976 F-32 Journal

Post by WayWeGo » Fri Feb 08, 2019 11:42 am

As prowlersfish mentioned, there are valid reasons to replace the original anchor light. In fact, that is one of the reasons we installed a radar arch on our boat. If you are still looking for a light mast, I have one that I might part with.
1975 F-36 Convertible
Twin Chrysler 440's

User avatar
BradZ
Sporadic User
Posts: 105
Joined: Thu Oct 04, 2018 8:08 pm

Re: Refitting a 1976 F-32 Journal

Post by BradZ » Fri Feb 08, 2019 9:39 pm

The reason I'm interested in the original is because my flybridge still has the old holes for the mast and outriggers. And the mast light I currently have is shot. I would rather install the original for now and when I redo the fly bridge I'll change to the radar arch. This years budget is small due to all the repairs I need to do to make it safe on the water. Just looking to have a working light and cover the old ugly holes at the same time. I uncovered the lower hole a few weeks back.
Attachments
IMG_4712.JPG
IMG_4712.JPG (44.31 KiB) Viewed 1075 times
1976 Trojan F-32 Sedan Home Port is Catawba Island live in Wadsworth Ohio

User avatar
P-Dogg
2019 Forum Supporter
2019 Forum Supporter
Posts: 803
Joined: Wed Jun 22, 2011 7:15 pm
Location: Near Baltimorgue, where Maryland proves to the nation every day that gun control doesn't work.

Re: Refitting a 1976 F-32 Journal

Post by P-Dogg » Sun Feb 10, 2019 7:03 am

BradZ wrote:
Fri Feb 08, 2019 9:39 pm
This years budget is small due to all the repairs I need to do to make it safe on the water.
Glad to see you've got your priorities straight.
I needed a less expensive hobby, so I bought a boat!

User avatar
WayWeGo
2019 Gold Support
2019 Gold Support
Posts: 585
Joined: Fri Feb 13, 2015 11:13 am
Location: Oakton, VA / Rhode River - Chesapeake Bay

Re: Refitting a 1976 F-32 Journal

Post by WayWeGo » Sun Feb 10, 2019 10:50 am

If the mast is OK but the light itself is shot, why not just replace the light head? You can get a new one for about $40 at Amazon: https://www.amazon.com/Perko-1197DP0CHR ... PF3PEDSG9J

I still have to repair the holes from the original light mast. For now, I have just the screws back in the holes with a gasket and backer in the big hole for the wiring. Next winter when the boat is on the hard, I will be doing fiberglass repair on the flybridge and will address these holes along with painting the flybridge as the gelcoat is worn away in places.
1975 F-36 Convertible
Twin Chrysler 440's

User avatar
prowlersfish
2019 Gold Support
2019 Gold Support
Posts: 11491
Joined: Sat Nov 05, 2005 6:56 pm
Location: Lower Chesapeake Bay ,Va

Re: Refitting a 1976 F-32 Journal

Post by prowlersfish » Sun Feb 10, 2019 11:05 am

That Perko lamp will fit perfectly on the Trojan mast . I cover up the big hole on mine with a piece of starboard fwiw .
TROJAN F36 Conv.
6BTA Cummins diesels
Life is to short for a ugly boat :D
2009 TROJAN RENDEZVOUS
Port Kinsale 2010 & 2011. Solomons get together 2011.

User avatar
BradZ
Sporadic User
Posts: 105
Joined: Thu Oct 04, 2018 8:08 pm

Re: Refitting a 1976 F-32 Journal

Post by BradZ » Sun Feb 10, 2019 12:16 pm

I guess I'm just a stickler on making things as original as possible. So some how I'll get my hands on the original light mast. My flybridge is in good shape so a good buffing and it should shine up nice..
1976 Trojan F-32 Sedan Home Port is Catawba Island live in Wadsworth Ohio

User avatar
BradZ
Sporadic User
Posts: 105
Joined: Thu Oct 04, 2018 8:08 pm

Re: Refitting a 1976 F-32 Journal

Post by BradZ » Sun Feb 10, 2019 12:27 pm

OK I think I'm ready to close up the cockpit bilge with the new deck. All I need to do is replace some framing that I already have milled and ready to install. Clean up the wiring and add wire management where needed. Suspend the mufflers from the new framing. Then sheet the deck with plywood and fiberglass the whole deck. Bilge is cleaned up and painted and turned out really nice. It think I'm going to make a removable wood grate to cover the bilge area under the hatch to protect the steering tie rods from getting jammed up with something. That way I can use the space for storage too.
Attachments
IMG_5377.JPG
IMG_5377.JPG (87.14 KiB) Viewed 1061 times
IMG_5375.JPG
IMG_5375.JPG (86.72 KiB) Viewed 1061 times
IMG_5371.JPG
IMG_5371.JPG (95.49 KiB) Viewed 1061 times
IMG_5365.JPG
IMG_5365.JPG (81.83 KiB) Viewed 1061 times
IMG_5370.JPG
IMG_5370.JPG (91.46 KiB) Viewed 1061 times
1976 Trojan F-32 Sedan Home Port is Catawba Island live in Wadsworth Ohio

User avatar
Captrichc
2019 Gold Support
2019 Gold Support
Posts: 228
Joined: Mon Jul 30, 2018 7:08 pm
Location: Bronx, NY

Re: Refitting a 1976 F-32 Journal

Post by Captrichc » Sun Feb 10, 2019 6:51 pm

Brad looks awesome. Im not far behind you with my rebuild as well.
1974 f32 Sedan
Twin 233 Mercruisers

User avatar
BradZ
Sporadic User
Posts: 105
Joined: Thu Oct 04, 2018 8:08 pm

Re: Refitting a 1976 F-32 Journal

Post by BradZ » Sun Feb 10, 2019 8:28 pm

Thanks Captrichc… Should be done framing everything this coming weekend. Then plywood with fiberglass/gelcoat and then some non skid of some sort...
1976 Trojan F-32 Sedan Home Port is Catawba Island live in Wadsworth Ohio

User avatar
WayWeGo
2019 Gold Support
2019 Gold Support
Posts: 585
Joined: Fri Feb 13, 2015 11:13 am
Location: Oakton, VA / Rhode River - Chesapeake Bay

Re: Refitting a 1976 F-32 Journal

Post by WayWeGo » Sun Feb 10, 2019 9:05 pm

prowlersfish wrote:
Sun Feb 10, 2019 11:05 am
That Perko lamp will fit perfectly on the Trojan mast . I cover up the big hole on mine with a piece of starboard fwiw .
That Perko lamp is the same that was on my Trojan mast, and also the same that came with the mast I bought from Atlantic Towers.
1975 F-36 Convertible
Twin Chrysler 440's

User avatar
BradZ
Sporadic User
Posts: 105
Joined: Thu Oct 04, 2018 8:08 pm

Re: Refitting a 1976 F-32 Journal

Post by BradZ » Sun Feb 10, 2019 9:08 pm

If anyone has the mast light I'm willing to buy it from them for a reasonable price...
1976 Trojan F-32 Sedan Home Port is Catawba Island live in Wadsworth Ohio

User avatar
BradZ
Sporadic User
Posts: 105
Joined: Thu Oct 04, 2018 8:08 pm

Re: Refitting a 1976 F-32 Journal

Post by BradZ » Tue Feb 19, 2019 10:12 am

Ok I'm almost there.. lol. As always I didn't accomplish what I wanted to but I did make progress. One note I would like to throw out there. The old framing was white oak. After much deliberation I went with treated yellow pine instead. My thought being if treated wood was around back in the day manufactures would have probably used it instead. Either way this framing is built stronger and more robust than the old framing and I'm sure will last another 40 odd years. Next step is to remount the muffler straps to hold the mufflers level with the LWL. Then lay the marine plywood decking. Notice the larger deck hatch it will finish at 36" x 49". This makes the area under the cockpit more accessible, therefore more useful. I moved the water pump back towards the bulk head to keep it out of the way. And I'm making a new mount for the Trim Tab Pump so it stays out of the way as much as possible.
Attachments
IMG_5410.JPG
IMG_5410.JPG (69.37 KiB) Viewed 978 times
IMG_5408.JPG
IMG_5408.JPG (98.06 KiB) Viewed 978 times
IMG_5406.JPG
IMG_5406.JPG (99.63 KiB) Viewed 978 times
1976 Trojan F-32 Sedan Home Port is Catawba Island live in Wadsworth Ohio

mikeandanne
Moderate User
Posts: 573
Joined: Sun Sep 09, 2012 11:30 am

Re: Refitting a 1976 F-32 Journal

Post by mikeandanne » Sat Mar 02, 2019 9:45 am

Just a thought, while you guys have it open have you considered replacing the exhaust hose, it looks pretty old.
78 F 32

User avatar
BradZ
Sporadic User
Posts: 105
Joined: Thu Oct 04, 2018 8:08 pm

Re: Refitting a 1976 F-32 Journal

Post by BradZ » Sat Mar 02, 2019 5:41 pm

I can still access the exhaust hose and I inspected the few small pieces connecting the exhaust pipe to the muffler and Thru hull fittings. It all is still in good shape as far as I can tell.
1976 Trojan F-32 Sedan Home Port is Catawba Island live in Wadsworth Ohio

Post Reply