Throttle Control "covers"

This forum is for comments and the exchange of information relating to Trojan Boats and boating. Please do not post used parts or boats For Sale in this area. For general, non-boating topics please use our "General Discussions" section.

Note: Negative or inflammatory postings will not be tolerated.

Moderators: BeaconMarineBob, Moderator, BeaconMarineDon

Post Reply
User avatar
Lucky7
Registered user
Posts: 12
Joined: Wed Aug 28, 2019 2:32 pm

Throttle Control "covers"

Post by Lucky7 »

Hello Everyone,

I have a recently purchased 1989 10.8 International. As you can see from the picture below the throttle "covers" (not sure what you call them) are old, stained and falling off. I tried searching for new ones but can't seem to find anything. Was wondering if anyone has found a good source for this or if it would be better to just make a new one myself out of gasket material. I was actually looking for one that covers the entire opening better ... like the bristles on a paint brush.

Thanks in advance,
Ron
Capture.PNG
Capture.PNG (250.03 KiB) Viewed 3134 times
1989 Trojan 10.8M International
Twin 454 Crusaders
User avatar
WayWeGo
2024 Gold Support
2024 Gold Support
Posts: 782
Joined: Fri Feb 13, 2015 11:13 am
Location: Oakton, VA / Rhode River - Chesapeake Bay

Re: Throttle Control "covers"

Post by WayWeGo »

Have you checked with Bob at Beacon Marine? 609-713-4602
1975 F-36 Convertible
Twin Chrysler 440's
User avatar
Lucky7
Registered user
Posts: 12
Joined: Wed Aug 28, 2019 2:32 pm

Re: Throttle Control "covers"

Post by Lucky7 »

WayWeGo wrote: Wed Sep 18, 2019 11:21 am Have you checked with Bob at Beacon Marine? 609-713-4602
Thank you. I checked his web site but I didn't actually call him. I can try that. Thanks.

Ron
1989 Trojan 10.8M International
Twin 454 Crusaders
Post Reply