SPARE PARTS?

This forum is for comments and the exchange of information relating to Trojan Boats and boating. Please do not post used parts or boats For Sale in this area. For general, non-boating topics please use our "General Discussions" section.

Note: Negative or inflammatory postings will not be tolerated.

Moderators: BeaconMarineBob, Moderator, BeaconMarineDon

User avatar
Big D
Ultimate User
Posts: 2876
Joined: Sat May 01, 2010 10:39 pm
Location: Ontario, Canada

SPARE PARTS?

Post by Big D »

What does everyone carry on board for spare parts? I realize this will depend on an individual's mechanical comfort level but just curious and maybe it'll be a lightbulb moment for some.
She was a 1969 36 ft wooden beauty with big blue 440s that we'll miss forever.
And thanks to the gang, 2012 Trojan Boater Of The Year
User avatar
Paul
Active User
Posts: 1141
Joined: Fri Jun 10, 2005 1:02 pm
Location: Windsor Ont.

Post by Paul »

My spare parts list is as follows:

- of course spare points pre-mounted on their plate in case of electronic pick up failure
- spare impeller and housing
- spare belts
- spare fuel filter
- spare alternator
- spare distributor cap & rotor
- spare set of spark plugs
- assorted hose clamps
- extra oil & trans fluid
- a box with gasket material, gasket adhesive, silicone, rubberized tape, pipe sealer, electrical connectors, wire, etc.

Funny thing is though, on the occasions that I've had to use items from my spare parts inventory it was usually to get somebody else's boat home safely. :lol:
Paul
"Cruise Control" 1978 F-26HT
"No Control" 2012 9' Grand RIB
jimbo36
Moderate User
Posts: 602
Joined: Mon Apr 21, 2008 9:20 pm
Location: Belleville, Ontario

Post by jimbo36 »

Big D, your spare parts should be based on what your boat may need regardless of your personal mechanical comfort level. As Paul say's, moat of his spare parts have helped others out. This is one of the best things about boating. Most of us will gladly help our fellow boater whenever possible. Not unlike this forum. jimbo36 :wink:
User avatar
Big D
Ultimate User
Posts: 2876
Joined: Sat May 01, 2010 10:39 pm
Location: Ontario, Canada

Post by Big D »

Good idea on the gasket material Paul. I have a lot of spare stuff on board but didn't even think of that. Never needed it on the water though, but now that it's been mentioned and Murphy is always along for the ride, I'll be keeping some on board.
She was a 1969 36 ft wooden beauty with big blue 440s that we'll miss forever.
And thanks to the gang, 2012 Trojan Boater Of The Year
User avatar
Paul
Active User
Posts: 1141
Joined: Fri Jun 10, 2005 1:02 pm
Location: Windsor Ont.

Post by Paul »

I've only ever had to use the gasket material once but I've kept some on board ever since.

Oh yeah, I also keep a spare prop and puller on board as well. I learned about this as the school of hard rocks. :D
Paul
"Cruise Control" 1978 F-26HT
"No Control" 2012 9' Grand RIB
User avatar
Big D
Ultimate User
Posts: 2876
Joined: Sat May 01, 2010 10:39 pm
Location: Ontario, Canada

Post by Big D »

Yah been there too. Always keep my scuba gear on board (usually leads to looking for peoples glasses and jewelery)
She was a 1969 36 ft wooden beauty with big blue 440s that we'll miss forever.
And thanks to the gang, 2012 Trojan Boater Of The Year
Danny Bailey
Moderate User
Posts: 478
Joined: Thu Dec 29, 2005 10:44 pm
Location: Oriental, NC

Post by Danny Bailey »

Spare parts are no good if you don't know where you put them. I make a parts list and then write beside each part where it is hidden. There are a lot of hiding places on my F-36. The list keeps me from having to search all the cubbyholes.
1980 F-36 with 6BTA 250 Cummins enjoying the Sounds and coastal waters of North Carolina
User avatar
alexander38
Ultimate User
Posts: 3179
Joined: Sat Sep 27, 2008 6:48 am

Post by alexander38 »

1, carb 2, fuel pump 3,filters 4, belts 5, gaskets 6,raw water pump 7,thunderbolt IV backup system 8, duct tape :lol: and zippy ties :lol: :lol: :lol: :arrow:
Carver 3607 ACMY 454's Merc's
10' Dinghy 6hp Merc.
La Dolce Vita
Let's hit the water !

http://s852.beta.photobucket.com/user/t ... 8/library/
foofer b
Ultimate User
Posts: 1320
Joined: Sun Oct 05, 2008 8:45 pm
Location: Black Creek, Florida
Contact:

Post by foofer b »

A twelve pack, a bag of chips, some bean dip, a magazine and the SEa Tow number!!
MY CURRENT FLEET
2003 KEY WEST 2020 WA
1978 14' ASHCRAFT SKIFF
Image
Audrey II
Sporadic User
Posts: 120
Joined: Mon Nov 01, 2010 8:43 pm
Location: Haverstraw, NY

Post by Audrey II »

I have a diesel so electronic ignition parts which are a good idea I I never carried on my last boat but should have are not on my list, but I used to carry spare set of wires and plugs this save my butt on one trip.R

I carry 4 Raycor filters, 2 fuel filters, 2 oil filters, 3 impellers, belts, distilled water, oil, anti freeze tube of gasket sealer, I plan to pick of an emergency peg plug set just in case, duct tape, electrical tape and assortment of connectors and wire, plumbing fittings Flair-it type connectors assortment, spare bilge pump. Tool kit with anything I would need to install any of the above including a big knife to cut a line I might pick up with my prop, I plan to pick up a face mask to help with this. I'm sure I missing several things
Image
1996 Trojan 440
larglo
Moderate User
Posts: 743
Joined: Fri Jul 17, 2009 4:01 pm
Location: Mt Juliet, TN. Percy Prist Lake, Fate Sanders Marina

Post by larglo »

foofer,

I'm with you pal. :D But, I'm on what most would consider a small landlocked lake. If I were on the ocean, or the gulf, it would be a completely different story. :!:

Larry
Geoff R
Registered user
Posts: 57
Joined: Sat Dec 04, 2010 9:40 pm
Location: Ottawa Canada

Post by Geoff R »

ballast resistor and/or ignition coil ? Quality!! Duct tape And yes it depends a lot on where U are, how far you go, The type and age of your vessel , & do you have the tools and skills to put em in
Audrey II
Sporadic User
Posts: 120
Joined: Mon Nov 01, 2010 8:43 pm
Location: Haverstraw, NY

Post by Audrey II »

Even if you don't have the skills it pays to have the parts. I was Traveling with a friend last season separate boats but together half way through our 1 week trip he shredded an impeller. He called me in a bit of a panic not knowing what to do. I pulled up the first mooring I could find and had him raft up to me. I had to wait for the motor to cool to work on it but even though he would never have tried this himself he had the part. There is often someone else that can help in an emergency. If not of the temperature of the motor we would have been underway in a few minutes but it took about 1 1/2 hours and I burned my chest working on it but the vacation went on. The wives made lunch and we relaxed and enjoyed. while we waited for it to cool. Connecticut River leaving Essex Island nice trip will return again.

Having the parts are half the battle.
Image
1996 Trojan 440
Geoff R
Registered user
Posts: 57
Joined: Sat Dec 04, 2010 9:40 pm
Location: Ottawa Canada

Post by Geoff R »

Points well taken If you have the parts you are half way there
User avatar
Big D
Ultimate User
Posts: 2876
Joined: Sat May 01, 2010 10:39 pm
Location: Ontario, Canada

Post by Big D »

Agreed, even if you can't do it yourself, at least you don't have to rely on the marina you pull into to have it in stock or wait a few days for them to get it. Happened to a buddy in Georgian Bay. Stopped him for four days, and they charged him for docking while they waited for the part...ouch!
She was a 1969 36 ft wooden beauty with big blue 440s that we'll miss forever.
And thanks to the gang, 2012 Trojan Boater Of The Year
Post Reply