marine prop shaft repair /machine shop near DE or MD?

yorklyn · Post by **yorklyn** » Wed Jun 06, 2012 11:05 am

Any suggestions on a good place to get my shafts checked out and cleaned up prior to new cutlass bearings? I know I should be able to just take then to a machine shop but would prefer to deal with a place that works on marine equipment. had no issues with them before but figured since they were out I should have them looked over.

Thanks,
Todd

Mike Kulp · Post by **Mike Kulp** » Wed Jun 06, 2012 12:39 pm

Black dog propellers on kent island does props not sure of shafts. Miller's Island propeller at Sparrows point Baltimore can check or make you a new shaft.

yorklyn · Post by **yorklyn** » Wed Jun 06, 2012 2:10 pm

Thanks Mike,
Blackdog did a great job on my props awhile back. I checked their site before I posted this question and didn't see any info on shafts. I'll give both places a call.

Thanks again!

yorklyn · Post by **yorklyn** » Wed Jun 06, 2012 2:10 pm

Thanks Mike,
Blackdog did a great job on my props awhile back. I checked their site before I posted this question and didn't see any info on shafts. I'll give both places a call.

Thanks again!

yorklyn · Post by **yorklyn** » Wed Jun 20, 2012 8:40 pm

just an fyi, Blackdog only does props. Found a place in St Michaels md, Kastel brothers 410-745-2818. Spoke with them on the phone, great guys! very helpful. Will be taking the shafts struts and props to them soon.