If you love your Trojan

[Struts and Rudders]

Hello all,
After removing the fuel, water and waste deck fittings I am posting this.

My 1980 F36 had inadequate sealing around each of these fittings.
The coring was not properly finished and I have some rot around those fittings.

We're going back with epoxy over structural foam so we will never have this problem again but I strongly suggest you take a good look at your deck penetrations to assure they are sealed properly.

Not a Dutch treat....
SRD
1980 F 36

[alexander38]

That's problem with almost all boats, when I did my hatches I had to seal up the aft one