F-36 Fuel Tank Drawings
Moderators: BeaconMarineBob, Moderator, BeaconMarineDon
-
- Moderate User
- Posts: 478
- Joined: Thu Dec 29, 2005 10:44 pm
- Location: Oriental, NC
F-36 Fuel Tank Drawings
Anyone know where I can get dimensioned drawings of the right and left gas tanks for a 1980 F-36. I need to have aluminum ones built for diesel repower.
- prowlersfish
- 2024 Gold Support
- Posts: 12663
- Joined: Sat Nov 05, 2005 6:56 pm
- Location: Lower Chesapeake Bay ,Va
-
- Sporadic User
- Posts: 158
- Joined: Sat Oct 29, 2005 8:22 am
- Location: Taranna
up close and personal
Im replacing the aft bulkhead right now so the forward tanks are exposed. still need em?
F36 ~
SHES SOLDDDDDD
SHES SOLDDDDDD
-
- Moderate User
- Posts: 478
- Joined: Thu Dec 29, 2005 10:44 pm
- Location: Oriental, NC
-
- Sporadic User
- Posts: 158
- Joined: Sat Oct 29, 2005 8:22 am
- Location: Taranna
Im going to start tomorrow
we are putting in the new bulkhead port side tomorrow. the angle on the tank is also critical. the aft section is trapezoid so I'll figure out the angle also. One thing on reinstalling is to fabricate small brackets to stabilbize the longitudinal supports under the salon. these can attach to the tank location structures. Photos will show.
F36 ~
SHES SOLDDDDDD
SHES SOLDDDDDD
-
- Sporadic User
- Posts: 158
- Joined: Sat Oct 29, 2005 8:22 am
- Location: Taranna
17.5 inches wide, 23.5 inches deep check out http://boatdesign.net/forums/showthread ... #post80536 and look closely.
F36 ~
SHES SOLDDDDDD
SHES SOLDDDDDD