Capacity Plate F-32

This forum is for comments and the exchange of information relating to Trojan Boats and boating. Please do not post used parts or boats For Sale in this area. For general, non-boating topics please use our "General Discussions" section.

Note: Negative or inflammatory postings will not be tolerated.

Moderators: BeaconMarineBob, Moderator, BeaconMarineDon

Post Reply
MUSICMAN7775
Registered user
Posts: 13
Joined: Sat Jul 14, 2012 7:36 am

Capacity Plate F-32

Post by MUSICMAN7775 »

Good morning. I purchased the "PEDDLER" an F-32 in Sept. of 2013. Sold my F-26 to friends. Love these boats.
Anyway,the wording on the capacity plate on the lower helm in the sedan has been rubbed clean except the black border.
Would anyone happen to have a photo or know the exact wording on the F-32 Model 321 capacity plate,
or at least have the capacity numbers so that I can add them to my records. I assume the helm plate is where the cap. plate is located.
If you can help it would be appreciated.
Thanks, Don
mikeandanne
Moderate User
Posts: 628
Joined: Sun Sep 09, 2012 11:30 am

Re: Capacity Plate F-32

Post by mikeandanne »

on our 78 there is a plate there between the helm and the tab switches-----I have a photo but can't read wording,but as i remember it is a notice and warning-----there is another in the electric cabinet below----cant get within 30 ft due to snow but maybe by the wkend we can get in----Mike
comodave
Moderate User
Posts: 255
Joined: Tue Aug 16, 2011 8:07 pm
Location: Au Gres, MI

Re: Capacity Plate F-32

Post by comodave »

Capacity plates are not required on a 32' boat. Most manufacturers do not put them on larger boats, but they are allowed to put them on. On my boat the plate near the helm talks about running the bilge blower before starting the engine. That warning is required at each helm that can start the engine(s). A very general formula for capacity is length times beam and then divide by 15. However, I would not use that formula as a safe loading for any of my boats. On an F32 it works out to 27 people... I would never take 27 people on my F32. There was a case a couple of years ago of a 34' boat, maybe a Silverton, that capsized during a 4th of July fireworks show due to overloading. They had about that many people onboard. My 22' Triumph has a capacity plate that states 10 people, using the basic formula works out to 12 people. I have to abide by the plate and never carry more than 10. I would never even carry 10 because you would not have room to move around on the boat. On the F32 I think that 8 to 10 people would be a reasonable number of people, but opinions vary...
Trojan has been sold
1987 President 41 DC 225 Lehmans
Au Gres, Michigan
User avatar
gettaway
Active User
Posts: 1142
Joined: Mon Feb 15, 2010 1:48 pm
Location: Coronado CA

Re: Capacity Plate F-32

Post by gettaway »

I agree with Commodave,

here is the article about the boat that Commodave is referencing

http://www.soundingsonline.com/features ... y-to-carry
1984 Silverton 37C
Silver Lining
Scott
MUSICMAN7775
Registered user
Posts: 13
Joined: Sat Jul 14, 2012 7:36 am

Re: Capacity Plate F-32

Post by MUSICMAN7775 »

Thanks for all the information guys.
I do appreciate it.
If you can get a photo after the snow melts Mike, that would be great as that is where the plate is on mine.
Thank God for spring.
Doing new nav. gear and hydraulic tabs this week, so it begins.
Thanks.
Don
User avatar
captainmaniac
2024 Gold Support
2024 Gold Support
Posts: 1922
Joined: Sat Apr 30, 2005 10:26 pm
Location: Burlington, Ontario

Re: Capacity Plate F-32

Post by captainmaniac »

I have had 17 people (myself and wife included) on my F32 when we hosted my sister's wedding aboard. I will never take that many people again. I made sure people were distributed around the boat (4 of us on the fly bridge, 4-5 in the cockpit, 4 in the salon, and 4 in the lower cabin at the dinette). I never travelled any more than 1500 rpm / 8 knots, but the boat was noticeably more sluggish, didn't respond well to the wheel, and close quarters maneuvering was real fun! It was sitting almost 6" lower in the water.

The only time I let people freely move about the boat is when it was tied to the dock, and when we are sitting at anchor for the ceremony, and even then I limited the number of people allowed on the flybridge.
mikeandanne
Moderate User
Posts: 628
Joined: Sun Sep 09, 2012 11:30 am

Re: Capacity Plate F-32

Post by mikeandanne »

MUSICMAN7775 wrote:Thanks for all the information guys.
I do appreciate it.
If you can get a photo after the snow melts Mike, that would be great as that is where the plate is on mine.
Thank God for spring.
Doing new nav. gear and hydraulic tabs this week, so it begins.
Thanks.
Don
Hope you can read the wording on this,let's see---it snowed again yesterday,wow!!!!!----- Mike
Attachments
image.jpg
image.jpg (78.77 KiB) Viewed 4427 times
MUSICMAN7775
Registered user
Posts: 13
Joined: Sat Jul 14, 2012 7:36 am

Re: Capacity Plate F-32

Post by MUSICMAN7775 »

Thanks Mike.
I think I got it all.
Post Reply