Page 6 of 7
Re: Trojan International Logos
Posted: Mon Jun 30, 2014 9:05 am
by tsawyer
Wrap it up. I'm fine with it.
Thanks for all your work on this.
Re: Trojan International Logos
Posted: Mon Jun 30, 2014 6:07 pm
by todd brinkerhoff
RWS wrote:Personally I would like to see them all facing the correct direction as the logo was designed.
If y'all are good with this, I'll pull the trigger, I'd really like to get this finally done with.
If there is no objection I will get r dun - all facing forward....
Gentlemen?
RWS
Sounds good to me.
Re: Trojan International Logos
Posted: Mon Jun 30, 2014 11:30 pm
by yorklyn
im good!
Re: Trojan International Logos
Posted: Tue Jul 01, 2014 9:18 am
by RWS
since there are zero objections, the matter is now closed.
finally !
I will post here the day I ship.
RWS
Re: Trojan International Logos
Posted: Thu Jul 03, 2014 9:30 pm
by RWS
Picking them up Monday PM
Shipping Tuesday
Will confirm once they are all away !
RWS
Re: Trojan International Logos
Posted: Tue Jul 08, 2014 5:09 pm
by RWS
here they all are:
- this represents one set - either 10 meter or 10.8
- logosToMail070814.JPG (33.71 KiB) Viewed 10661 times
In addition to what everyone was expecting, in BLACK & PEWTER, we will each receive:
additional pair of 10 METER in silver
additional pair of INTERNATIONAL in silver
additional pair of incorrect SIDE LOGOS
Brinkerhoff will receive same as above, but his are 10.8
all will ship tomorrow.
I'll be happy when they are all gone !
T.B. I'll deposit your check AFTER all have shipped.
WHEW !
RWS
Re: Trojan International Logos
Posted: Tue Jul 08, 2014 5:19 pm
by bigrgh
your pic only shows one "trojan" logo, there are two ?
Re: Trojan International Logos
Posted: Tue Jul 08, 2014 5:31 pm
by RWS
bigrgh wrote:your pic only shows one "trojan" logo, there are two ?
==================================================================================
Yes, there are TWO, apparently one was trying to run back to the sign shop, or was just too plain shy to be included in the photo.
Re: Trojan International Logos
Posted: Tue Jul 08, 2014 9:42 pm
by todd brinkerhoff
Thanks for all your work on this RWS!!!!!
Re: Trojan International Logos
Posted: Tue Jul 08, 2014 10:50 pm
by yorklyn
Woohoo! Christmas in July!
Thanks for everything Harris!
Re: Trojan International Logos
Posted: Fri Jul 11, 2014 7:15 pm
by RWS
SHIPPED !
have tracking numbers, if anyone wants theirs, send me a regular e-mail.
RWS
Re: Trojan International Logos
Posted: Wed Jul 16, 2014 2:42 pm
by Bimmerbill
got mine yesterday. Thanks!
Re: Trojan International Logos
Posted: Wed Jul 16, 2014 3:32 pm
by todd brinkerhoff
Got mine!!!
Re: Trojan International Logos
Posted: Thu Jul 17, 2014 9:54 pm
by RWS
here's some photos of my installation.
One side now complete.
I used a heat gun a soft putty knife to remove what could be removed that way.
I used a 3-M Eraser wheel in an electric drill to get the parts that were basically melted/faded/fused into the gelcoat.
after a compound session, I wiped everything down with M E K (methyl ethyl keytone) its less harsh than lacquer thinner.
Peel the backing off. Then A few drops of DAWN in a spray bottle sprayed on the boat and on the back side of the vinyl will allow you to slide the sticker around for the best "fit".
squeegee it down, then gently peel the top paper off ON AN ANGLE!
Here's some pix.
RWS
- photo 1.JPG (32.97 KiB) Viewed 10608 times
- photo 2.JPG (46.61 KiB) Viewed 10608 times
- photo 3.JPG (35.08 KiB) Viewed 10608 times
Re: Trojan International Logos NOW WITH PIX
Posted: Thu Jul 17, 2014 9:56 pm
by RWS
finished job !
- photo 4.JPG (36.48 KiB) Viewed 10608 times
RWS