Page 1 of 1

Where to find Porthole visors for my 74' Trojan

Posted: Fri Jun 06, 2008 4:47 pm
by jwrape
My Trojan is missing2 of those white rubbery porthole visors seen on the side of the boat here. Where can I find them?
Image

Posted: Fri Jun 06, 2008 4:52 pm
by Stripermann2
Welcome to the board!

Try John at Marine Tech. 717-684-4145 be sure you know which model boat you have when inquiring for parts and info. I believe you have the 44 MY. Good luck.

Posted: Fri Jun 06, 2008 4:54 pm
by jwrape
Stripermann2 wrote:Welcome to the board!

Try John at Marine Tech. 717-684-4145 be sure you know which model boat you have when inquiring for parts and info. I believe you have the 44 MY. Good luck.
Great, Thanks. Does he have a nice selection of all kinds of Trojan parts oris it limited? I plan to replace a few other things of course and need a good parts supplier since there is not much around for these boats in GA.

Posted: Fri Jun 06, 2008 4:58 pm
by Stripermann2
John and Larry were with Trojan before they went out. Good guys but dependant on what you need, they may have or be able to tell you best where to get a specific item/part. Other than Trojan parts, you can pretty much get other marine related parts just about anywhere.

Posted: Fri Jun 06, 2008 5:01 pm
by jwrape
Stripermann2 wrote:John and Larry were with Trojan before they went out. Good guys but dependant on what you need, they may have or be able to tell you best where to get a specific item/part. Other than Trojan parts, you can pretty much get other marine related parts just about anywhere.
Yea, there are a lot of upgraded parts on the boat, CB, GPS, Stereos but as for the gauges that stopped working and other parts i would like to replace with original instead of replacing all the gauges to keep them looking the same across the dash.
My Port temp gauge doesn't work on the top deck, but the gauges in the aft salon work good. Might be wiring but I think it's the gauge.

Posted: Fri Jun 06, 2008 5:10 pm
by Stripermann2
Then in that case, get a hold of John on Monday talk over your needs with him and see if he can supply you with a wiring diagram and any other info to help you along. He's a good source of information. Good luck.

Posted: Fri Jun 06, 2008 5:11 pm
by jwrape
Stripermann2 wrote:Then in that case, get a hold of John on Monday talk over your needs with him and see if he can supply you with a wiring diagram and any other info to help you along. He's a good source of information. Good luck.
Thanks for the info. I appreciate it!