Trojan Boat Forum

Has anyone used one of these ?

https://www.boatdesigns.com/prodinfo.asp?number=90-112

I am about to replace my rudder with this one on my F26

http://www.deepblueyachtsupply.com/prod ... uctid=1429

And I figure I change the stuffing while at it....any suggestions...

Thanks

PS

Anyone have the measurements for these

Base size:
Length below base:
Below Base OD:

No, but it looks like a nice design ...

I've always wondered why the rudder tube isn't extended above the water line, thus avoiding any leak issues.

You sent me a message about the pdf I have of the rudder, but I must have zapped it into the netherworld. Send me an email at rfpssp@aol.com and I'll send you what I have. I don't have the measurements, but I do have information on stuffing - pretty straightforward - not much need to mess around with it when it's done, wiht possible tightening over every few years.

Thanks Randy

Anyone have or know wre I can get a build card/hull card about this particular boat if you provide the hull ID