Trojan Boat Forum

Hi all,

I am wanting to replace the oil pressure sending unit in my F25- HT. The sending unit is in a difficult location to remove, so haven't done that yet.

I would like to order the water sender and the oil press sender, but I am not sure what size the oil sending unit is. I can see that the stem with the threads is about half the size of the water temp stem, which 1/2".

All West Marine have on line is the 1/8" - 80psi & 1/8"-100psi. Does anyone out there know what size I should order? Perhaps some of you with a F26 would know.

Thanks for any help.

Larry

call beacon marine the website sponser see if they can help

you might have to reduce it down.

Most oil pressure sending units have a 1/8 inch pipe thread.