New ignition system on 318s
Posted: Tue Jul 10, 2007 9:49 pm
Has any one removed the stock electronic ignition on their 318s. I would like to remove the system as to eliminate the ballast resistor. Even though it is a $6.00 part it is a pain in the butt. I put electric fuel pumps on my boat and wired them like the instructions show, to the coil, but the ballast resistor drops the voltage to much. The pumps would not run on the 8 volts going to the coil. After trouble shooting for a few hours trying to figure out why the pumps wouldn't run, I rewired to a 12 volt source and the pumps work great. Then soon after I lost spark to the port engine and traced that back the ballast resistor. Now reading about upgrading the system to an after market product , I found ACCEL makes a distributor that has all the componets inside, meaning I can eliminate the control module and ballast resistor. By doing this I would have new carbs, new fuel pumps and a new ignition system, hopefully a trouble free system. The ACCEL unit has a full 12 volts going to the coil and the coil puts out almost 50,000 volts to the plugs allowing you to open the gap of the plugs and possibly gaining a little better fuel burn.
Any comments would be welcomed., Jim
Any comments would be welcomed., Jim