Page 1 of 1
Calling F32 owners
Posted: Wed Jan 28, 2015 8:44 am
by mikeandanne
I am away from the boat and need to know the exhaust pipe size at the transom, specifically the inside I.D.....wanting to order something and take it home with me....Thanks if anyone can help....I know there is a pic there with a tape on it but it is on a bit of an angle and there is only 1/4" wiggle room with these screens I want to get......anyone....Thanks Mike
Re: Calling F32 owners
Posted: Wed Jan 28, 2015 2:55 pm
by comodave
I just measured mine 3.5" inside and 4.0" outside
Re: Calling F32 owners
Posted: Wed Jan 28, 2015 6:46 pm
by mikeandanne
Thanks much for that sir, now I can order the screens. ...min size is 3.75" with 1/4" wiggle room so I think we are ok....again very much appreciated...Mike
Re: Calling F32 owners
Posted: Thu Jan 29, 2015 9:31 pm
by TC
Hey Mike. Did I stir you up with the mustrat story? If you find something down south post or PM me a picture and a price. We may both be after the same thing. Comodave's picture there looks dangerously like my tips. Looks like I will be making the drive either this weekend or next to get pics and measurements.
Re: Calling F32 owners
Posted: Thu Jan 29, 2015 10:11 pm
by mikeandanne
TC wrote:Hey Mike. Did I stir you up with the mustrat story? If you find something down south post or PM me a picture and a price. We may both be after the same thing. Comodave's picture there looks dangerously like my tips. Looks like I will be making the drive either this weekend or next to get pics and measurements.
Partially, but I was going to make extensions to cut fumes down and as it turns out those guards apparently act as diffusers as well....maybe kill two rats with one stone...hehe.....well long story short the smallest one fits 3.75 i.d. to 4.5" sooooo if ours are all 3.5" as Commo's are then then we are out of luck...let me know what your actual measurements are.....Mike
By the way I sent you a pm