Trojan Boat Forum

we had same thing after tuning her up...turned out it was the NEW set of wires....

Jimmy

Hi All Still working on our 1980 F26 flybridge project. Comming along slow, but lookin good. After sitting a few years we are running old fuel out of her mixed with fresh. What should our top speed and RPM be ? We did a short haul cleaned and painted bottom and installed new 13in prop. She has a 200...

http://www.cooperss.com/1-1-26612-Trojan?tab=Photo Gallery&page=4#photos

A buddy sent this to me..its around the corner from me..any one interested...going tonight to take a look.

Jimmy

Does anyone have and would care to share the dash console for a 1980 F26 Flybridge.
I am in process of rebuilding console and wires are labeled from factory, but would like to have a list of what goes where.

Thanks in advance

Jimmy

Was down working on her last night and checking fuses...looks like # 6 or # 9 fuse as it is marked keeps blowing...without tracing anyone have oe scematic on what device this controls ?

Jimmy

Well
Our project is comming along slow...just had her short hauled after 4 years being in water...other than some barnicals she looks good.. Tonight pulling prop.. Can any one say what size should or could be on her ? She was repowered in 2002 with a Mercruiser small block chevy.

Thanks

Thank You ready........will try that if cant find..BTW Your boat looks GREAT !!!!!!!!!!

Jimmy

MTB LOL Great Idea...dont have a cat.....think neighbors will do ?

all the windows seem to be plastic...foreword window seems to be bowed, not flat...It also has a Taylor Made sticker on it.

I mainly need the weatherstrip...looks like a roll of fur LOL

Original bacame so distorted after removing.... I will look in the Depot today..

Thanks

Jimmy

Hi All AGAIN

I am looking for the thin aluminum band or tape that is used on the original headliner....most local shops never heard of it ....

Thanks Jim

Just removed bow and side cabin windows on our 1980 F26 flybridge. Wanted to reseal while cabin is apart. Has anyone replaced the welting or weatherstripping in window channel . We removed ,but noe have to replace. We also want to change sliding windows on side...Any suggestions on to what to use ? ...

LOL,,,, You will have them turning heads looking up here in NY with those horns

Great Job Paul !!!!!!!!!!

WOW...Some Great interiors...cant wait to put back together to post pix...The area below windows ..is fabric glued or just stapled...our boat had like a basket weave wall paper and cant tell if it had foam or glue then stapled.....
Thanks

Keep interior pix comming...getting great ideas