Trojan Boat Forum

I have a 1985 Trojan 10 meter International fly bridge. I have window leaks and would like to get new window channels. Can I get their dimensions and where I could purchase them?

TKS

Don

Tks for the reply. I have the 10 meter international, fly bridge. Meant partition in outline, had another problem with the salon air and needed it repaired. As a result had to recharge and wanted the birth unit looked at as well. A picture may be appropriate.

I have a 1985, 10 meter international. It has the aqua temp air front and salon. I recently had the salon unit recharged but couldn’t get complete access to the front birth. I removed the vent cover but am unable to gat the full patriot off. It will not go past the wood border on the small table spa...

Tks for the response. My closet is on the port side the ac is starboard on top of a small set of drawers. There must be an easy way to charge the front ac unit as removing the panel seems like it is going to be a lot of work.

I have a 1985 Trojan 10 meter fly bridge. This summer I had to have some work done on the air conditioning. I was able to do the work and recharge the salon unit however the vbirth unit is giving me trouble. I can remove the grill but when I try to get back to the unit I can’t get the main panel pas...

I have a 1985, 10 meter International. Recently my ac unit quit and when I removed the digisette control switch it was clear that a couple of wires had overheated and melted. It may be hard to rewire and I have tried to search for a switch but have not found one. Is there a suitable replacement avai...

My engines are twin crusader 454s with mallory (yu670av) distributors. I want to replace the distributors but my marine part suppliers have not been able to find compatible replacements.

Could someone point me in the right direction?

The situation has yet to be resolved. Going out 1 more time this week before being put on land. Hopefully will be able to check out voltage.

We are looking for something obscure as I don't believe the issue is with the gas, carbs or distributor. The message about the blowers is interesting as the timing for the problem is about 20 minutes out on the lake. My International has the house battery combination on the port side and I always ru...

Checked this last year but will give it another look as the symptoms seem to be getting
worse

Only one mech on board. Scratching head, nothing seems out of order, no idea what is wrong.

Okay, just an update: Swapped out the carbs and electronic ignitions, put new pickup tube in tank Timing was checked and went out for a run. Got up to 3200 revs for about 15 mins and port engine again started to fall off. When you tried to throttle back up she started to back fire. She finally stall...

I am going for a new carb and will be testing on lake with 2 mechanics on board.

Thanks all

Going to try flexible tubing to see if there is a clog in the intake. I am also going to get a new or rebuilt carb and see if either issue is what is causing the problem