Trojan Boat Forum

there is a nut and bolt through supports easy to remove as well as the back of the platform it is very easy to remove with minimal tools i have the same set up on my 1977 f32

thanks for the info i saw one today and it was made out of metal and powder coated i think that might be my ticket

i bought my 1977 f32 repo in october both motors runs strong some coring issues on port bow with new genny for 4k maybe this will give you an idea

let me just start by saying your f32 is outstanding i can only hope to get mine looking that good!
it is the piece that covers the opening on the angle where the back window would open to the aft deck i have seen several with this white panel covering that area

i am looking for the side rear outside part of the window the blank off any idea where i can find them

I HAVE RECENTLY PURCHASED A 1977F32 AND I HAVE AN ISSUE WITH THE EDGE OF THE BRIDGE SEPARATING AT THE DRIP EDGE WHAT IS THE FIX FOR THIS I HAVE FOUND A SOURCE OF WATER GETTING TO THE EDGE IT WAS THROUGH THE SCREWS HOLDING THE DRIP EDGE ON. HAS ANY ONE REMOVED THE DRIP EDGE AND DID AWAY WITH IT MY F3...

THAT WOULD BE A 1980 F308 TROJAN WITH ALOT OF MODS THEY HAVE A 12'3" BEAM IT HAD A GALLEY DOWN WHICH IS NOW CONVERTED INTO A SIDE STATE ROOM