Rudder Stuffing. Got another Question

Aviso Grille · Post by **Aviso Grille** » Sun Jan 04, 2009 1:36 pm

Has anyone used one of these ?

https://www.boatdesigns.com/prodinfo.asp?number=90-112

I am about to replace my rudder with this one on my F26

http://www.deepblueyachtsupply.com/prod ... uctid=1429

And I figure I change the stuffing while at it....any suggestions...

Thanks

PS

Anyone have the measurements for these

Base size:
Length below base:
Below Base OD:

rossjo · Post by **rossjo** » Mon Jan 05, 2009 12:05 am

No, but it looks like a nice design ...

I've always wondered why the rudder tube isn't extended above the water line, thus avoiding any leak issues.

randyp · Post by **randyp** » Tue Jan 06, 2009 11:29 am

You sent me a message about the pdf I have of the rudder, but I must have zapped it into the netherworld. Send me an email at rfpssp@aol.com and I'll send you what I have. I don't have the measurements, but I do have information on stuffing - pretty straightforward - not much need to mess around with it when it's done, wiht possible tightening over every few years.

Aviso Grille · Post by **Aviso Grille** » Tue Jan 06, 2009 3:45 pm

Thanks Randy

Aviso Grille · Post by **Aviso Grille** » Tue Jan 06, 2009 3:45 pm

Anyone have or know wre I can get a build card/hull card about this particular boat if you provide the hull ID