Trojan Boat Forum

7/8" or 1" rails?

I'll add 7/8" 90degree Tees and Round Bases to the list.

Anyone need 1" Tees/bases?

i will have to measure its a 78 f32.,i assume they are what was originally installed. do these come with set screws for installation? or must they be welded? what did you finally come up with for a price?

Set screws ..

rossjo wrote:7/8" or 1" rails?

I'll add 7/8" 90degree Tees and Round Bases to the list.

Anyone need 1" Tees/bases?

I would assume mine are 7/8... Don't think they are an inch... I need to go out to see.

For those of you interested in replacing your grab rail fittings, my company (http://www.RNR-Marine.com) uses 1" fittings in our products, and can buy and sell Whitecap's fittings at a good discount over your retail prices.

I am offering pairs (2 each) of any of the following Whitecap brand (http://www.whitecapindustries.net) AISI Type 316 polished, cast stainless rail fittings for $19.99 plus actual shipping:

• Pair #6093 , 316 S.S. 7/8" 60° Universal Tee (not used on F32)
  Pair #6044 , 316 S.S. 7/8" 60° Left Tee (F32 uses this style)
  Pair #6045 , 316 S.S. 7/8" 60° Right Tee (F32 uses this style)
  Pair #6040 , 316 S.S. 7/8" 60° Round Base
  Pair #6043 , 316 S.S. 7/8" 90° Tee
  Pair #6039 , 316 S.S. 7/8" 90° Round Base

• Pair #6193 , 316 S.S. 1" 60° Universal Tee
  Pair #6140 , 316 S.S. 1" 60° Round Base
  Pair #6143, 316 S.S. 1" 90° Tee
  Pair #6139 , 316 S.S. 1" 90° Round Base

We accept payment via PayPal only (easy - no PayPal account required, just your email address, and you enter your credit card yourself). Just email me with your need (Qty # Part#), and I'll forward a PayPal payment request to you ...

Do you know if the stanchion base bolt hole pattern lines up with the originals?  I tried West Marine and a few local ship stores and never found any that matched.  Figured I would have to fill in the old holes with epoxy and drill new ones.

I don't have any of the round bases in stock, so I'll get some in and check ...

The 60-degree Tees (Left and Right) measure out to be an exact replacement for the F32's rail Tees, with 1-3/8" between the set screw holes. I plan to replace the set screws with stainless steel 1/8" rivets to match the orginal holes in the F32's rails.

They sent the bolt circle measurements on the round base, but I'm waiting for a sample part to verify angles ...

We added a Rail Fittings section to our web purchase page ...
http://www.RNR-marine.com/Purchase.html ... l-Fittings