Page 3 of 4
Posted: Sun Mar 14, 2010 3:31 pm
by gardnersf
My part numbers were different but I have a H series.
Wires - ON1671631 and ON1671632 (One is longer than the other)
Plugs - ON1670199
Posted: Sun Mar 14, 2010 7:30 pm
by alexander38
are you using the shielded plugs and metal covered wires with the $800.00 coil ? Those numbers I gave out replace those
Posted: Tue Mar 16, 2010 6:03 pm
by gardnersf
yes, so these are acceptable replacements?
Aslo I cannot find the EIK in stock anywhere. 160-1376. Anyone know where to get one?
Posted: Fri Mar 19, 2010 10:45 am
by gardnersf
if I convert to the Electronic Ignition kit, do I still need the condenser?
Posted: Fri Mar 19, 2010 7:41 pm
by alexander38
no on the condenser
Posted: Sat Mar 20, 2010 9:00 pm
by gardnersf
Thanks,
I ordered the cables, spark plugs and coil to go with the EIK kit I found. Hopefully the generator will run much better after the overhaul.
Posted: Sun Mar 21, 2010 6:19 am
by alexander38
where did you find the kit.
Posted: Mon Mar 22, 2010 12:53 am
by gardnersf
I was contacted by a member of Smokstak forum. He had three in stock, (now two)
I then ordered the RCCK coil, wires, and plugs. Thansk for the numbers.
Posted: Mon Mar 22, 2010 7:08 pm
by alexander38
thanks again Scott, he's down to one.
Posted: Sat Mar 27, 2010 5:05 pm
by alexander38
Well back to square one again the thing wouldn't start today. Got the whole carb kit last week and I'll be puttin it in next week when I get the EIK for it.
Posted: Thu Apr 08, 2010 3:30 am
by alexander38
ok here we go,going to do the following today. Install re-done carb, new gas pump and EIK and new coil and plugs and wires. It better run like a new one when I'm done.
Posted: Fri Apr 09, 2010 5:17 am
by alexander38
it's a live ! and running well.
Posted: Mon Apr 12, 2010 12:45 pm
by gardnersf
Great to hear! I'm planning on starting the work next week. May pull the carb this week and rebuild if I get the chance. I ordered the new coil, wires and plugs per your part numbers and have the EIK kit.
Anything particlualry difficult?
Does it seem to run better?
Posted: Mon Apr 12, 2010 8:10 pm
by alexander38
it was pretty much just bolt it in. But I installed the whole EIK base and cover that came with it. Did you get the new push rod for it you'll need it. you need any help e-mail me my BB is on all day.
Posted: Tue Apr 13, 2010 9:20 pm
by gardnersf
I see that a base comes with the EIK. Too bad I spent money on an extra base. My have to ebay that off.
Did you have to trim any metal form the EIK other than the nub on the base?