Page 6 of 6
Posted: Sat Feb 11, 2012 7:58 pm
by jefflaw35
Me to, just had a busy cold day, just settling down now and ready for some info, is it fabricated? If so can I have specs and material type so I can make some? Or what did it come off of?
Posted: Sat Feb 11, 2012 9:16 pm
by Paul
I bought it new here in Windsor but it but I believe it was manufactured in
Michigan. I'll get some more info in it and post it.
Posted: Sat Feb 11, 2012 11:18 pm
by jefflaw35
Thanks Paul, I'm tossing around everyone's suggestions, but if it helps me to have both to decide on my own then I'm good. I can change rudder and prop while in the water so it's not a problem to us. I would like to feel both side for myself
Posted: Thu Feb 16, 2012 8:52 pm
by Paul
The rudder came from Marine Machining & MFG in Clinton Twp. Michigan. (586) 791-8800.
Posted: Thu Feb 16, 2012 9:00 pm
by foofer b
Bump
Posted: Thu Feb 16, 2012 9:18 pm
by Paul
Paul wrote:The rudder came from Marine Machining & MFG in Clinton Twp. Michigan. (586) 791-8800.
Here's the link
http://www.marinemachining.com
Posted: Thu Feb 16, 2012 9:20 pm
by jefflaw35
Thanks Paul I appreciate it!!!
Posted: Fri Feb 17, 2012 3:18 am
by Torcan
Thanks Paul
going to look into it