Trojan Boat Forum

Hi all. I just bought a twin screw f30 express and am going to be pulling her out to paint the bottom and change out the Cutlass bearings while shes out. Would anyone happen to know the bearing size? I plan to get in the water tomorrow and take my own measurements but any info would be greatly appreciated so I can get these ordered. I have twin screws with 1" shaft diameter. I need OD and length that Trojan uses on these boats.

Thanks!

Best to wait until you can confirm the measurements however I'm thinking that you'll have 1"x 1 1/4" x 4" Morse Blackfish in the struts.

Thanks Paul. At least this gives me a base for comparison. Helps a bunch