Page 1 of 1
10 meter port holes
Posted: Wed Nov 18, 2009 10:23 pm
by bigrgh
Hi everyone! Its Ron with my first question .(of many i am sure!) I need to repair or replace port holes on my 84 10 meter. One has a broken trim ring on the outside,can it be repaired? and three need hinges and lock hardware on the inside and i also want to replace all of the seals(gaskets). does anyone know if i can get these parts? or what has anybody else done. any info will be apreciated.
Posted: Thu Nov 19, 2009 8:16 am
by Jerry
Call Bob at Beacon Marine Supply. They are the ones that keep this forum going and specialize in Trojan parts. His number is on the home page.
Posted: Thu Nov 19, 2009 7:22 pm
by RWS
Bob @Beacon Marine or John @ Marine Tech
There were two versoins of these portlights.
The earlier one was a simple flat tinted lens with six thumbscrews on the inside. This one hasa simple gasket available that ca be easily replaced.
The later models had stainless frames.
RWS
Posted: Fri Nov 20, 2009 7:48 am
by Jerry
RWS wrote:
There were two versoins of these portlights.
The earlier one was a simple flat tinted lens with six thumbscrews on the inside. This one hasa simple gasket available that ca be easily replaced.
The later models had stainless frames.
RWS
Which International had the 6 thumb screws on the inside? I have never seen one.
Posted: Fri Nov 20, 2009 12:56 pm
by RWS
perhaps it's less... I'll have to check next time i'm onboard.
Posted: Sun Nov 22, 2009 7:24 pm
by RWS
It's FOUR plus the hinge, not SIX.
RWS
Posted: Tue Nov 24, 2009 2:55 am
by bigrgh
Thanks. hopefully they have parts!