Trojan Boat Forum

I sent an email to Bob, I have two bent stanchions which are probably beyond getting straightened.

thanks,
Bob

Most railings were made within the Factory(Trojan), your best bet is to have a canvas guy re-bend it for you since they should have the bender for making top frame's.

I just bought a new bow pulpit railing from Bob at Beacon, That is where I go for most of my needs.

to either repair or replace.

I bought the whole pulpit rail new, they have parts, for a lot of the trojan stuff, one of the partners was an engineer for trojan and wound up with a trove of parts etc.