Trojan Boat Forum

hello all looking for a small piece of teak. if you have something, the smallest it can be is apx 7"x10" x 1/2" thick, no veneer. anybody have a small scrap they can part with? if you have something let me know how much. thanks
tennessee just isnt the place for teak, i cant imagine why

here is a dealer in Knoxville that deals in boat teak
http://www.woodfinder.com/listings/015104.php
Jeffries Fine Lumber
Contact: Cynthia Jeffries
Address: 8807 Valgro Road
Knoxville, TN 37920
Phone: 865-573-5876
Fax: 865-573-6367

West Marine has it as well. It's a rip off but they have smaller pieces like that.

thanks for the 2 replys so far but i have done plenty of research on line and i was hoping that someone here might have something that will be reasonable .

bobct west marine doesnt have anything like this they dont have lumber in the width i need.

torcan i called them they want $39.85 and i have 3hr roundtrip drive to get it. too much cost there.

i'll keep hoping someone here has some access to some scrap. i know when i'm in fla there are some great salvage yards that have this stuff lying around for hardly anything. i just dont have access to this in tn.

i dont mind paying for it if the price is reasonable.

g36 wrote: torcan i called them they want $39.85 and i have 3hr roundtrip drive to get it. too much cost there.

No problem, but you don't need to drive, couldn't you get them to USPS the piece you need?
Guess it all depends on how much your willing to pay.

Good luck
james

I have talked with Beacon about Teak and they have a pretty good supply. I had them rebuild my swim platform for my f28 and it came out like new.

torcan
she said she would not send it and i would have to pick it up.

the reason i am asking here is i figured with this many people on the forum someone would have some lying around. i'm not asking for a hand out but $40 is a bit much for this small amount of wood. when i was in florida last i picked up a piece twice as large and 1 1/4 " thick for $12.00. its just that florida is 8 hrs away. if someone doesnt have any i will look into starboard or similiar but i would like to have a piece of teak.

I have teak laying around. I'll check the sizes and let you know. I'll give it to you, just re-imberse postage.

Hank

will also check....[can get lots of bits on ebay,I've purchased planks,strips.and cut offs w no problems...usually cheap too...]

There is a guy in Wilmington NC that is parting out a wooden Trojan 42 or something like that.

Look him up on craigslist, he has all kinds of stuff posted there. Including planks and trim parts.

He will sell cheap and ship to you.

SRD
F36

G36 9" x 14" x 1", aprox . rough cut....will need to be planed,trimmed etc,do you have a jointer/planer ?

Teak in Tennessee...as a matter of fact there was a period of time that a lot of teak was bought and used in TN.

I would venture to say that more boats are built in TN than any other state.

MasterCraft
Malibu
Supra
Moomba
Axis
Hydra Sports
Bryant
Allison
Gibson Houseboats
Triton
Sea Ray
Yamaha Jet Boats

Just to name a few of the builders in TN.....

struts ... you forgot chris craft, but anyway yeah there once was a time. teak used to be around alot but now more and more plastic and less beautiful teak.

peter i sent you a pm

jersdevil i sent you a pm