Trojan Boat Forum

Anybody run into secondhand outrigger poles that will fit the Lee junior holders I got from Bob...Let me know.

Thanks, Rick - F-36 / MissKitty

What is the inside ID of the holders ?

Think they are Lee Juniors with 1-7/8 inch inside to inside the Holders.

Thanks , Rick

Do you think or do you know thats the ID ? better be sure ass this can be costly $$$$$$ been down that road on other things

Well...I caint be 100% sure because the boat and holders are in Pensacola and I caint get back down there until next week. But...My buddy in P-cola went out to the dock and measured and thats what he came up with. He say`s they are 1-7/8 inside to inside.

Thanks, Rick

Perko makes a 1.9" pole 1 7/8 is 1.875 a .025 difference real close . I hope there perko as the can save you some $$$$ on the poles ( lees are out of sight ) a inside mic. or caliper would be nice

http://www.foreandaftmarine.com/9-1798015ALU.htm

http://www.foreandaftmarine.com/Outriggers.htm

Try to get a short enough length to fit under your local bridges. Putting them up/down or waiting for the draw or swinging bridge are a real pain.

Good luck - try a country wide Craigslist Search!

We have removed the outriggers from my boat.
I have no use for them.
They are the triple spreader type...in fair condition.
I have the entire system...mounts poles etc

$ ?