Trojan Boat Forum

gents,

I machined some new control lever knobs for my boat project as the stock ones were pretty haggered. I machined them out of black acetal (delrin) and while I was at it I used up all the material I had on hand in case someone else would like some. I figure I'd like to support the board as much as I can!

I have 25 knob assemblies left over but since there are 4 knobs per full set that makes 5 sets available. Just let me know and I'll send them out for free (first come first serve).

Nice job , Wish they would fit mine .

Paul,

What do you have?

I have round knobs , I don't really need any, but you did such a nice job making them .

nice job...pm coming your way..

Natchamp, I sent a PM to you. Also quick question about your generator rebuild. I also have mine out and in the garage for service. Where did you get parts from , and was that white paint high temp.? Thanks again.

I got most of my parts from onanparts.com but below are some links to additional resources. For paint I just used rustoleum, they don't get "that" hot and rustoleum covers pretty good.

http://onanrebuilding.com/
http://onanparts.com/
http://www.pplmotorhomes.com/parts/onan ... arts-1.htm
http://www.m-and-d.com/index.html?id=BbuLnf2n

And don't forget http://www.smokstak.com/forum/ for good info!

I would love a new set. jimmiedcharters@yahoo.com

JimmyD,

Send me your address and I'll ship them to u.

I would love to have a set mine are breaking up, can they be painted ?

Acetal is pretty adverse to paint. It's slippery stuff, can't imagine anything sticking to it.

Sorry Mark, they all went pretty fast and I have given them all away.

Bummer, thats what I get for not paying attention.

Any chance you would make some for sale?

Thanks Mark they fit great

Looking good Mike, glad to help.