Trojan Boat Forum

Any suggestions on a good place to get my shafts checked out and cleaned up prior to new cutlass bearings? I know I should be able to just take then to a machine shop but would prefer to deal with a place that works on marine equipment. had no issues with them before but figured since they were out I should have them looked over.

Thanks,
Todd

Black dog propellers on kent island does props not sure of shafts. Miller's Island propeller at Sparrows point Baltimore can check or make you a new shaft.

Thanks Mike,
Blackdog did a great job on my props awhile back. I checked their site before I posted this question and didn't see any info on shafts. I'll give both places a call.

Thanks again!

Thanks Mike,
Blackdog did a great job on my props awhile back. I checked their site before I posted this question and didn't see any info on shafts. I'll give both places a call.

Thanks again!

just an fyi, Blackdog only does props. Found a place in St Michaels md, Kastel brothers 410-745-2818. Spoke with them on the phone, great guys! very helpful. Will be taking the shafts struts and props to them soon.