Page 1 of 1
quick project (for a change )
Posted: Sun Jul 21, 2013 9:27 pm
by prowlersfish
I just added 2 foot switches on the bow for the windlass . Took about 30 minutes .
Re: quick project (for a change )
Posted: Sun Jul 21, 2013 10:13 pm
by vabeach1234
Nice.
But how long did it take you to decide where you wanted them? I know if it were me, it would have taken a month of just thinking about it.
Re: quick project (for a change )
Posted: Sun Jul 21, 2013 10:44 pm
by prowlersfish
Unlike the transom door that took years of thinking about it , I did this on impulse .I found a deal and bought them was even looking .
Re: quick project (for a change )
Posted: Mon Jul 22, 2013 5:56 am
by alexander38
Did you take pics? As you know I have the same Good Winch, show your wire hookup ans such..
Re: quick project (for a change )
Posted: Mon Jul 22, 2013 6:45 am
by prowlersfish
Just the one photo I posted . Wiring is simple , the red wire from each switch to power , then the other wire from each swith to the small "triger" termal on the solnoid(s )
Re: quick project (for a change )
Posted: Tue Jul 23, 2013 3:41 pm
by alexander38
No doubt it was ez..but a picture is worth a 1000 words....
Never mind
Re: quick project (for a change )
Posted: Tue Jul 23, 2013 7:28 pm
by prowlersfish
prowlersfish wrote:Just the one photo I posted . Wiring is simple , the red wire from each switch to power , then the other wire from each swith to the small "triger" termal on the solenoid(s )
Just to make it clearer the other wire goes to the same termals that the helm switch uses .
If i have my camera with me next time I can take a shot , not much to see just some solenoids and wires .