Power Loss Port Engine

Big D · Post by **Big D** » Wed Jul 25, 2012 11:38 am

ready123 wrote:Two engines one tank is still two anti siphon valves!

+1

lawyerdave71 · Post by **lawyerdave71** » Thu Jul 26, 2012 2:00 pm

I HAVE BEEN HAVING THE SAME PROBLEM WITH MY PORT - BEEN DRIVING ME NUTS.

Somedays - no problem whatsoever!

Other days - engine dies but fires right back up.

I need to do some more fine tuning but I think its a fuel problemo!

djmair · Post by **djmair** » Fri Jul 27, 2012 1:33 pm

djmair wrote:
boatsnbars wrote:Can you swap the fuel lines from one pick up to the other? If you can and it is a check valve the other engine should now have the problem.
Can't swap, copper pipe. Kind of hard to get to but I am going to see if I can remove the port line.

Ok guys this is the big weekend. Going to remove the gas line from the tank and check the valve. Kind of worried about gas spill over but I guess it wont be too much.

some people's kids · Post by **some people's kids** » Fri Jul 27, 2012 4:40 pm

Hey just ran into this last week , if both motors run on the same tank and one is loosing power u should look at the coil on the motor loosing power, let me guess after it cools u don't have a problem till it heats back up ?................the coil is bad

larryeddington · Post by **larryeddington** » Fri Jul 27, 2012 5:50 pm

Swap the coils and see.