Bulkhead replacement

This forum is for comments and the exchange of information relating to Trojan Boats and boating. Please do not post used parts or boats For Sale in this area. For general, non-boating topics please use our "General Discussions" section.

Note: Negative or inflammatory postings will not be tolerated.

Moderators: BeaconMarineBob, Moderator, BeaconMarineDon

Post Reply
Merchdoor
Registered user
Posts: 11
Joined: Sun Jun 11, 2017 7:43 pm

Bulkhead replacement

Post by Merchdoor »

F30 - I am replacing my bulkhead between the cabin and engine room. While removing the rotted wood I noticed that the rear deck is supported only in the middle by the two main stringers. Since there was so much bad work done on this boat I am questioning if this support is correct. I have two main stringers running down the center spaced approx. 2’ apart and two others spaced approx. 2’ over from the centers.
Top
User avatar
prowlersfish
2025 Gold Support
2025 Gold Support
Posts: 12723
Joined: Sat Nov 05, 2005 6:56 pm
Location: Lower Chesapeake Bay ,Va

Re: Bulkhead replacement

Post by prowlersfish »

Should also have support on the sides , you may not see it . What model F30 they made several
Boating is good for the soul
77/78 TROJAN F36 Conv.
6BTA Cummins diesels
Life is to short for a ugly boat :D
Top
Merchdoor
Registered user
Posts: 11
Joined: Sun Jun 11, 2017 7:43 pm

Re: Bulkhead replacement

Post by Merchdoor »

Thank you. I have a Clean Machine.
Top
Post Reply

Return to “Trojan Boats Forum”